Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the left-hand rear mounting bracket for the Hettich Quadro V6 undermount drawer slide system, designed specifically to anchor the rear of the slide in face-frame cabinet construction using a dowel-mount fixing.
Undermount slides in face-frame cabinets cannot attach directly to the cabinet side at the rear — the face frame creates a setback that leaves the back of the slide unsupported. This rear mounting bracket solves that problem by giving the Quadro V6 slide a fixed anchor point at the cabinet back. The dowel-mount fixing seats into a bored hole, keeping the bracket locked in position without additional fasteners. The 25 mm depth adjustment built into the bracket then lets you shift the slide fore and aft to line up the drawer front without repositioning the bracket itself.
The bracket is molded in plastic sized and shaped to the Quadro V6 slide profile. Plastic construction keeps weight minimal in an application where the bracket carries alignment loads rather than the full drawer weight — the slide itself bears the load, while the bracket holds position. The dowel-mount geometry is specific to the Quadro V6 series; the hole pattern and seating dimensions are not shared with earlier Quadro versions or other Hettich undermount programs.
Cabinet shops running Quadro V6 slides into face-frame boxes reach for this bracket on every drawer opening where the slide needs rear support. It is also the part most commonly missing from a first shipment when a shop switches from frameless to face-frame work mid-project. Designers and contractors specifying Quadro V6 in traditional American kitchen and bath cabinetry should confirm rear bracket quantity alongside the slide order — one left-hand and one right-hand bracket per drawer opening. The bracket is sold individually, so order in pairs to complete each opening, and in quantities that match the drawer count for the job.
No. In frameless cabinets the Quadro V6 slide mounts directly to the flat cabinet side panel at both front and rear, so no rear bracket is needed. This bracket is the face-frame solution only.
The bracket is listed for the Quadro V6 series. Confirm compatibility with the specific Quadro V6 variant in your installation — 2D and 4D locking devices and accessories are version-specific within the Quadro family.
Once the bracket is seated, the slide can shift forward or back within 25 mm of range. That movement lets you correct drawer front gap and alignment after the box is hung, without pulling the bracket out and re-boring.
Hettich offers drilling templates for the Quadro series; using the correct template for the V6 program ensures accurate hole placement for the press-in dowel. Using a template sized for a different series will produce an off-location bore.
A missing or mismatched rear bracket is the fastest way to lose drawer-front alignment in a face-frame install — getting this left-hand piece right, paired with its right-hand counterpart, means the Quadro V6 system performs as specified from the first drawer to the last.
Sold In: 1 Each