Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the right-hand cabinet profile for Blum's TANDEMBOX drawer system, a steel runner that mounts inside the cabinet and carries the drawer to a full-extension, soft-close stop. At 400mm nominal length, it suits standard kitchen and bath drawer depths and brings BLUMOTION damping to the cabinet side of the pair.
A TANDEMBOX drawer runs on two cabinet profiles (one per side) and two drawer members (one per side). This right-hand profile is the cabinet-side runner for the right wall. It anchors to the cabinet interior, accepts the drawer member at loading, and controls the motion sequence as the drawer opens and closes. Without it, the right side of the drawer has no running surface and no damping. The 400mm nominal length determines which drawer members and back panels pair with it — all components in one drawer must share the same nominal length. Cabinet depth must accommodate the system's published installation clearance for this nominal length.
The profile is formed steel, zinc-plated for a clean, corrosion-resistant surface that holds up in humid kitchen and bath environments. The zinc finish is a functional choice — it protects the steel runner surface where the drawer member rides, keeping the action consistent across years of daily use. BLUMOTION is built into the profile, not added on as an aftermarket part, so the damping geometry is optimized for the TANDEMBOX runner travel rather than approximated with a clip-on unit. This is a production component, not an entry-level runner; it carries the same construction as the full TANDEMBOX program.
This profile is the right component for cabinet shops running TANDEMBOX as their primary drawer system and needing to replenish individual members, complete a partial order, or build at a specific nominal length. Designers and specifiers who have called out TANDEMBOX with BLUMOTION on a project can source the exact right-hand component here without substituting a different motion class. Homeowners replacing a damaged profile on an existing TANDEMBOX installation will want to confirm the nominal length and handedness of the existing runner before ordering — this profile replaces the right-hand cabinet member only.
One working TANDEMBOX drawer requires two cabinet profiles (left and right), two drawer members (left and right), a back panel, and the appropriate front fixing brackets. Locking devices and cover caps are ordered separately and are TANDEMBOX-specific.
No. All components in a single drawer — cabinet profiles, drawer members, and back panels — must share the same nominal length. Mixing lengths in one drawer is not supported.
TANDEMBOX installs in both frameless and face-frame cabinet constructions, but face-frame applications require the appropriate rear mounting bracket, which is sold separately and is TANDEMBOX-specific. Check Blum's published installation requirements for the nominal length and construction type.
No. BLUMOTION is a damped soft-close — a hydraulic damper slows the drawer to a silent stop. Self-close uses a spring or ramp to pull the drawer shut with a positive click. This profile is soft-close, not self-close.
Plain BLUMOTION profiles and TIP-ON BLUMOTION are separate Blum products. TIP-ON (push-to-open) combined with soft-close requires the integrated TIP-ON BLUMOTION unit, not a standard BLUMOTION profile. Verify the intended opening method before ordering.
One right-hand cabinet profile in the correct nominal length is the piece that completes the right side of a TANDEMBOX drawer — with full extension and BLUMOTION damping built in, not bolted on afterward.
Sold In: 1 Each