Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This 500mm right-hand cabinet profile is the wall-mounted runner that anchors the TANDEMBOX drawer system on the cabinet side, integrating BLUMOTION soft-close damping directly into the runner. It is a single handed component — the right-hand cabinet member — sold individually so shops and installers can replace or complete a specific side of a drawer installation.
In a TANDEMBOX installation the cabinet profiles mount to the cabinet box walls and carry all the running load; the drawer members ride on them. This right-hand profile mounts to the right interior wall of the cabinet opening at the 500mm nominal length. It is the piece that receives the drawer member when the drawer is pushed closed, and it is where the BLUMOTION damper engages to decelerate the drawer over the last portion of travel. Replacing or adding a cabinet profile without the matching drawer member leaves the drawer incomplete — both sides need the correct cabinet profile for the drawer to run and close.
This component is used in frameless cabinet construction where profiles mount directly to the cabinet side panel on the 32mm grid. For face-frame cabinets, confirm that the appropriate rear mounting hardware for the TANDEMBOX system is on hand before installing.
The profile is formed steel with a zinc-plated finish. Zinc plating delivers a consistent metallic surface that is visually neutral inside the cabinet and resistant to the light abrasion and contact that comes with daily drawer use in a production kitchen or shop environment. The finish coordinates with other zinc TANDEMBOX components so a consistent look carries through the system interior. Because this is a precision-engineered system part, nominal length, height, and finish must match across all TANDEMBOX components in the same drawer — mixing lengths or series within one installation is not supported.
A single right-hand cabinet profile is the right order for a cabinet shop replacing a damaged runner on a completed installation, completing a partial set where one side arrived short, or staging components in advance for a large run of drawers where right and left sides are kitted separately. Installers who build out drawers in volume often order cabinet profiles and drawer members independently to match their cut lists, rather than purchasing pre-paired sets. This profile also suits design-build firms specifying TANDEMBOX with BLUMOTION soft-close who need to confirm component availability before finalizing a kitchen or closet project.
This is a single right-hand cabinet profile. To complete one drawer you need a left-hand cabinet profile plus two drawer members — one for each side of the drawer box.
It is made for the 500mm TANDEMBOX nominal length. All components in one TANDEMBOX drawer — cabinet profiles, drawer members, and back — must share the same nominal length and be from the same TANDEMBOX series. Confirm your existing components are 500mm before ordering.
The BLUMOTION damper is integrated into this cabinet profile — there is no separate clip-on unit to add. Once the profile is mounted, soft-close is active.
TANDEMBOX profiles are designed for direct side-mount in frameless cabinets. Face-frame installations require rear mounting hardware specific to the TANDEMBOX system; confirm you have the correct brackets before proceeding.
Other TANDEMBOX zinc components — drawer members, backs, and front fixings — carry the same zinc finish designation. Order all components in zinc to keep the system interior consistent.
One missing or damaged cabinet profile stops an entire drawer from functioning correctly. Having the right-hand 500mm zinc TANDEMBOX profile with BLUMOTION on hand — whether for a repair, a replacement, or a component-level build — means the drawer goes back in service without waiting on a full-set reorder.
Sold In: 1 Each