Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice Series 200 concealed hinge is built for cabinet boxes set at a 30-degree outward angle, the geometry found in bay cabinets, diagonal corner units, and angled appliance garages. It hangs overlay doors on both face-frame and frameless cabinets with a self-close spring and screw-on mounting.
Bay cabinets and diagonal corner units create an angled front face that a standard 0-degree hinge cannot bridge. This hinge is engineered to the +30-degree cabinet angle so the door hangs plumb and closes cleanly against an angled box. The 35mm cup bores into the back of the door in the standard position, and the arm geometry takes care of the offset. A matching base plate mounts to the cabinet and is sold separately; use a Salice plate matched to your cabinet construction. The 94-degree swing is the correct opening for this application, giving clear access without the door swinging into an adjacent cabinet or wall panel.
The hinge body is steel in a nickel finish. Screw-on mounting delivers a firm, fixed connection directly to the frame stile or cabinet side, which suits angled installations where the hinge sees lateral stress each time the door swings. The self-close spring keeps the door from drifting open, a practical detail on a diagonal front that may not sit fully plumb. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm and minus 1.5mm let the installer dial in the reveal after the door is hung.
This hinge belongs on bay-style kitchen runs, diagonal corner cabinets, and any angled face-frame or frameless box where the cabinet wall meets the door at 30 degrees rather than 90. Cabinet shops building custom angled units and contractors fitting specialty corner configurations will find this hinge the direct solution rather than a workaround. For a square cabinet box, a standard 0-degree hinge is the correct pick. For a soft-close damped close rather than a spring pull, choose the Silentia+ version of this series.
It refers to the angle of the cabinet box itself, not the door swing. A +30-degree hinge is built for a cabinet whose front face is angled 30 degrees outward from the wall run, as in a bay or diagonal corner unit. A standard hinge on this box would leave the door misaligned.
Yes. The hinge arm connects to a base plate that mounts to the cabinet side or stile, and that plate is sold separately. Use a Salice plate matched to your cabinet type. Plates are brand-specific and will not interchange with other brands.
No. This is a self-close hinge: a spring pulls the door shut over the last few degrees of travel. It does not cushion or slow the close. For a damped, quiet close on an angled cabinet, choose the Silentia+ soft-close version of this series.
Yes. On a 30-degree angled cabinet, 94 degrees of swing is the engineered opening for this application. The reduced angle relative to a standard 110-degree hinge is intentional: it keeps the door clear of the adjacent cabinet panel as it opens.
When the cabinet box is built at 30 degrees and a standard hinge simply will not work, this Salice Series 200 angled hinge delivers the geometry, the overlay position, and the reliable spring close the job calls for.
Sold In: 150 Each