Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice Series 200 hinge is built for inset doors that sit flush inside the cabinet opening, with integrated Silentia soft-close and screw-on mounting, on both face-frame and frameless cabinets.
An inset door sits within the cabinet opening rather than covering it, framed by a consistent gap on every edge. That look demands precise geometry, and this hinge delivers it: the full crank arm holds the door at the inset position as it swings, and the 94 degree opening is the angle engineered to let the door clear the face frame or panel edge without binding. The 35mm cup bores into the back of the door at a 45mm bore pattern, and the hinge screws to a separate base plate on the cabinet, ordered separately. Pair it with a Salice plate matched to your cabinet construction.
The hinge body is steel finished in nickel, a neutral, durable tone that sits quietly behind closed doors. Inset work is held to tighter tolerances than overlay, so the Silentia soft-close earns its place here: it removes the impact from daily closing and protects the precise fit over time. The plus or minus 2mm height adjustment and the side adjustment let you dial in the reveal after the cabinet is assembled, which matters on inset doors where an uneven gap is immediately visible.
This is the hinge for cabinet makers and finish carpenters who are building or renovating with flush inset doors on face-frame or frameless boxes. It suits furniture-quality casework and kitchen or bath projects where the door surface and the frame face are meant to read as one plane. Screw-on mounting is a deliberate choice here: it skips the clip mechanism for a direct, mechanical connection that holds steady on a precisely fitted door. For doors that overlay the cabinet side rather than sitting inside it, an overlay hinge is the correct pick. For doors over 22mm thick, move to a thick-door hinge.
No. The hinge mounts to a base plate that is sold separately. Use a Salice plate matched to your cabinet type. Plates are brand-specific, so plates from other manufacturers will not connect to this hinge.
The 94 degree angle is correct engineering for an inset door. The door sits inside the opening, so the swing geometry needs to clear the face frame or panel edge as the door opens. The reduced angle is by design, not a limitation.
It is built in. No separate damper or adapter is needed. The Silentia mechanism slows the door over the final degrees of travel so it closes without impact.
Yes. This hinge works on both face-frame and frameless cabinets when paired with the appropriate Salice mounting plate for each construction type.
When the design calls for inset doors that sit even with the frame and close without a sound, this hinge delivers the geometry, the damping, and the adjustment to make it hold.
Sold In: 1 Each