Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice Series 200 hinge is built for handle-less cabinet doors at a half overlay position, releasing the door outward at a press through a self-open mechanism on both face-frame and frameless cabinets.
Handle-less cabinet fronts are common in modern kitchens, closets, and built-ins where a clean, uninterrupted face is the goal. This hinge pairs that look with a half overlay door position: each door covers part of the cabinet side, and where two doors share a single center partition, the half crank geometry keeps both arms from colliding. Press the door closed and it latches; press it again and the self-open mechanism pushes it out. The 35mm cup bores into the back of the door, and the arm connects to a base plate mounted to the cabinet. That plate is a separate item, brand-specific to Salice, ordered alongside this hinge.
The hinge body is plated steel. The nickel finish makes it a straightforward match when drawer slides, hinges, or other hardware in the same installation already run in nickel. The dowel mount on the cup side is a production-oriented detail: instead of cup screws, pre-attached dowels press into bored holes in the door, which keeps the CNC or shop workflow moving without a secondary fastening step at the door.
This hinge fits cabinet shops and contractors running handle-less kitchen or bath projects where speed and finish consistency matter. The dowel cup attachment suits a CNC-bored workflow, and the half crank geometry covers the standard shared-partition scenario without special setup. It is designed for standard door thickness up to 1-3/8 inches; doors outside that range need a different series. The self-open mechanism requires a free-swinging door, so pairing this hinge with a spring self-close or soft-close hinge on the same door is not the right combination.
Yes. This hinge connects to a Salice base plate that mounts to the cabinet side or face frame. The plate is sold separately. Use a Salice plate matched to your cabinet construction and desired overlay position. Plates from other brands will not connect to this hinge.
When the door is pressed closed, an internal spring holds it. A second press releases and pushes the door outward so it swings open without a handle. This is a push-to-open function, not a soft-close or self-close mechanism.
The 94 degree opening is intentional for self-open applications, where a controlled, moderate swing keeps the door from swinging wide. It provides practical access without the door traveling into an adjacent space.
The cup uses pre-attached dowels that press into bored holes alongside the 35mm cup hole. This is standard for CNC production lines set up for dowelled hinges. If your current setup uses cup screws instead, check whether your boring pattern matches before ordering.
Specify this hinge when the design calls for handle-less half overlay doors that open at a touch, finished in nickel to blend with the rest of the installation.
Sold In: 300 Each