Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic set supplies end caps, clips, and screws for the SYMA32 handleless profile handle system, in Matte Silver. Every cut end of a SYMA32 run needs a cap to close the exposed channel section, and this set delivers the caps along with the fastening hardware to secure them.
Handleless profile handles arrive in lengths and are cut to fit the cabinet run. That cut leaves the hollow cross-section of the profile open at each end. Left uncapped, the open channel shows the interior of the extrusion and can collect dust and debris. Capping both ends is the last step that turns a cut length into a finished element. Because runs end on both a left side and a right side, left and right caps are both required, and this set supplies both in a single purchase.
Most handleless components in this range ship as the part alone, with no fastening hardware. This set is different: the product name states that clips and screws are included alongside the caps. That matters when ordering for a job where every component has to be on-site before installation can move forward. Matte Silver is a cool, low-sheen tone that sits naturally alongside contemporary frameless cabinetry without drawing attention to the profile ends.
Cabinet shops and installers running Rinco-Matic SYMA32 profile handles in Matte Silver will need one set of end caps per profile length. Designers specifying a handleless kitchen in a neutral, modern palette often land on Matte Silver for its versatility across light and dark cabinet finishes. Because the SYMA sizes each take their own components, confirm that your profiles are the SYMA32 before ordering. SYMA14 and SYMA2 profiles take different cap sets.
Yes. A left cap and a right cap are both supplied, so one set finishes one profile run at both ends.
No. This set is made for the SYMA32 series. The other SYMA sizes have their own cap sets and the components are not interchangeable.
Not with this set. The product name confirms that two clips and two screws are included.
No. This is a Rinco-Matic SYMA32 component. Schwinn profiles run a separate system and their components are not compatible with Rinco-Matic profiles.
Order one set per profile length to close out a SYMA32 installation cleanly, with clips and screws already in the package.
Sold In: 1 Set