Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic set supplies the left and right end caps needed to close out a SYMA32 profile handle run, along with the clips and screws to secure them. It is a purpose-built finishing component for the SYMA32 system, sold in Matte Black.
Handleless profiles arrive in long stock lengths and are cut to the width of each cabinet run. That cut leaves the hollow cross-section of the extrusion open at both ends, exposed at the edge of the door or drawer front. On a dark, matte-finished installation, an open channel end reads as a raw detail that breaks the visual line the system is meant to create. This set closes both ends so the run finishes cleanly at the left side and the right.
Matte Black is a demanding finish choice precisely because every component in the run has to stay consistent. A gloss, a sheen difference, or an exposed raw end draws the eye immediately against a flat dark surface. This set is finished in Matte Black to sit within the SYMA32 family's matte finish range. Note that finish names differ between Rinco-Matic and other handleless suppliers, and no cross-supplier finish match is implied.
Cabinet shops and kitchen installers running Rinco-Matic SYMA32 profile handles in Matte Black will need this set at every profile run that has an exposed end. That includes runs that terminate at a wall, at a tall unit edge, or at a panel end where the cabinet stack does not continue. Both ends of a run are covered by one set. Confirm the SYMA size marked on your profiles before ordering: SYMA14 and SYMA2 are separate sizes and take their own components, not these.
Yes. The set includes a left cap and a right cap, so one set finishes a single profile run at both ends.
Yes. The product name states that two clips and two screws are included with the caps.
No. Each SYMA size takes its own end cap set. This set is made for SYMA32 profiles only.
No. Rinco-Matic and Schwinn are separate handleless systems and their components are not interchangeable.
One set closes both exposed ends of a SYMA32 profile run in Matte Black, with the clips and screws already in the box.
Sold In: 1 Set