Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic Gola 19 is a flat intermediate handleless profile in Matte Black, supplied in a 105-1/8 inch stock length. It fits between two cabinet fronts to create the recessed grip that replaces visible hardware across a drawer bank or door run.
A handleless cabinet elevation is not built from one universal section. Each profile position has a specific job. The intermediate profile occupies every horizontal joint between two cabinet fronts: it gives a gripping recess to the front below it and closes the gap above. On a three-drawer bank that means two intermediate profiles, one between the top and middle drawer and one between the middle and bottom. Each horizontal joint in the run gets its own length of profile, cut to the cabinet width.
The position also determines which companion profile handles the top of the run. Above the topmost front, an upper-side profile finishes the elevation. That is a separate item ordered alongside this one, not interchangeable with an intermediate. A run built entirely from intermediate sections leaves the top open.
Matte Black is among the most common finish selections for a handleless kitchen because it keeps the grip line subordinate to the door face. A flat, no-sheen black surface absorbs light rather than reflecting it, which is the effect that makes a Gola channel read as a shadow gap from across the room. The flat profile cross-section reinforces that geometry, sitting flush rather than projecting a contoured lip. The anodized or applied finish on a profile is a surface treatment applied at manufacture; the stock length arrives ready to cut and install. End caps and corner pieces that close the cut ends of the profile are separate items, specified to the Gola 19 series.
Cabinet shops and kitchen fabricators working on a handleless project in the Gola 19 system order this profile for every horizontal joint between fronts in the run. Designers specifying a matte black handleless elevation select it alongside the matching upper-side profile for a consistent finish across all horizontal lines. Contractors sourcing replacement sections for an existing Gola 19 installation in Matte Black will find this is the intermediate section for that system. At just over eight and a half feet per length, it ships as an oversized item rather than standard parcel, which is worth accounting for in project scheduling.
The intermediate profile fits between two fronts. The upper-side profile fits above the topmost front, where there is no front above it. They serve different positions in the elevation and are ordered as separate items.
No. Caps and corners are separate items specific to the Gola 19 series and are ordered separately.
No. Rinco-Matic Gola profiles and Schwinn L-channel profiles are separate systems with their own accessories. They are not interchangeable.
Count the horizontal joints between fronts in the run. Each joint takes one intermediate profile cut to the cabinet width. A three-drawer bank, for example, has two joints and needs two lengths.
Order one intermediate profile for each horizontal joint in the run, the upper-side profile for the top, and the matching caps and corners as separate items, and the Gola 19 elevation comes together as a continuous, hardware-free surface in Matte Black.
Sold In: 1 Each