Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Century Components front right bracket is the position-specific mounting hardware for the X2 pull-out system, securing the right-hand front corner of the carriage to the cabinet structure.
Pull-out systems depend on four brackets, one at each corner, to hold the carriage in position and keep travel smooth and straight. The front right bracket anchors the forward right corner of the X2 carriage, which is the corner that takes the most direct contact load every time the unit is pulled open. A damaged, missing, or incorrect bracket at this position lets the carriage shift or bind rather than tracking cleanly. This part restores proper alignment at that corner so the pull-out operates the way it should.
This bracket is manufactured to Century Components specifications for the X2 pull-out system. Because pull-out carriage hardware is position-specific, the front right bracket is not interchangeable with the front left, rear right, or rear left positions. The right-hand orientation and front placement are built into the part geometry, so installing the correct bracket at the correct corner is what keeps the carriage square and the slide travel consistent.
This bracket is most useful to cabinet shops building or servicing X2 pull-out units, and to homeowners or contractors replacing a damaged component in an existing installation. If an X2 pull-out is running rough, binding on one side, or sitting out of square, a failed front bracket is a common cause. Ordering the position-matched replacement rather than a generic bracket is what gets the unit back to factory alignment. For other positions in the same system, the front left, rear right, and rear left brackets are separate SKUs.
No. Each bracket position in the X2 system has its own geometry. This part is for the front right corner only and is not interchangeable with the other three positions.
It works for both. It is the same bracket whether you are assembling a new X2 pull-out or replacing a worn or damaged front right bracket in an existing unit.
Face the cabinet opening. The front right bracket mounts at the right-hand side of the carriage closest to you. If the damaged bracket is on the opposite side, that is the front left. If it is toward the back of the cabinet, you need a rear bracket instead.
Choose this front right bracket to restore proper alignment and smooth travel to an X2 pull-out, whether you are completing a new build or getting an existing unit running straight again.
Sold In: 1 Each