Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Century Components X 2 back right bracket is a position-specific mounting component designed to seat at the rear of a pull-out system on the right-hand side, keeping the carriage properly aligned and anchored inside the base cabinet.
In a pull-out organizer system, the rear brackets carry most of the alignment work. They hold the back of the carriage at the correct depth and angle so the unit slides true from the moment it leaves the front of the cabinet to full extension and back. A bracket in the wrong position, or one installed in place of a handed component, shifts that geometry and introduces binding or misalignment. This one is built for the rear right position specifically, so it drops into that role without adjustment.
The bracket is a right-hand part, which means it is not interchangeable with the back left bracket even if the two look similar. Position matters here: install this bracket at the back right of the carriage frame, where it mates with the corresponding mounting point. If you are rebuilding a damaged pull-out or sourcing hardware for a new installation, cross-reference the bracket position against the Century Components X 2 system layout before ordering, since each of the four bracket positions in the set is distinct.
This bracket is the right choice when one rear right mounting point has failed or gone missing from an otherwise sound Century Components pull-out, or when a cabinet shop or installer is building out a new unit and needs to source brackets individually. Homeowners completing a repair rather than a full pull-out replacement will also find this a practical solution since it avoids replacing components that are still in good condition.
No. The back right and front right brackets are position-specific components in the X 2 system. Installing a rear bracket in a front position, or vice versa, will not produce the correct fit and may prevent the pull-out from operating properly.
No. Although back brackets may look similar, right-hand and left-hand components are handed parts and are not interchangeable. Order the back left bracket separately if you need to replace that position as well.
This bracket is part of the Century Components X 2 pull-out system. Confirm that your pull-out unit is an X 2 series before ordering, since bracket geometry varies across pull-out families.
When the rear right anchor point on a Century Components X 2 pull-out needs attention, this bracket restores correct alignment without replacing the entire assembly.
Sold In: 1 Each