Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This aluminum design element is the decorative insert panel for the inner face of the TANDEMBOX drawer side at 22-inch nominal length and D-height, finishing the interior wall in Gray so the inside of the drawer box matches the look of the overall system.
The TANDEMBOX side profile is a structural steel wall, and the design element is the visible face panel that sits in the channel on the interior side. Without it, the inner wall shows the steel back of the profile. Installing the design element gives the drawer box a consistent, finished look from the inside — the kind of detail that matters in open-concept kitchens, glass-front cabinets, and custom interiors where the inside of the drawer is part of the overall presentation. At 22 inches, this element covers the full interior length of a 22-inch nominal TANDEMBOX drawer, from the back of the front fixing to the rear of the side profile.
The panel is aluminum, which holds a consistent surface quality edge to edge and presents a uniform appearance without the texture variation that can show up on painted steel. The Gray finish is part of the TANDEMBOX color program — the same Gray used on the side profiles and associated components — so the installed element reads as part of the drawer, not an add-on. Finish matching is the entire point of this component; ordering a different color element than the surrounding TANDEMBOX hardware will produce a visible mismatch inside the box.
This part is relevant when a TANDEMBOX installation calls for a finished interior — a spec that comes up most often in high-visibility cabinetry, designer kitchens, and built-ins where drawers are expected to look complete when opened. Cabinet shops finishing TANDEMBOX installations in Gray will typically need one design element per side per drawer; confirm the count against the number of drawer sides in the run. It is also a replacement part for existing TANDEMBOX drawers where a design element has been removed or damaged. This specific element is for the 22-inch D-height configuration; other lengths and heights are separate SKUs.
It clips into the channel on the interior face of the TANDEMBOX side profile, covering the structural steel wall with a finished aluminum panel. The result is a clean, consistent interior surface on both sides of the drawer.
D is the tallest of the standard TANDEMBOX side heights. If the side profiles in your drawer are any other height code, this element will not seat correctly — match the height code to your existing side profiles before ordering.
A drawer has two sides, so most installations need two design elements per drawer — one for the left side and one for the right. Count the sides in your installation when calculating quantity.
It will if your existing side profiles are TANDEMBOX Gray. TANDEMBOX is also available in other colors; confirm the color of the installed profiles before ordering to avoid a visible mismatch.
The design element fits the TANDEMBOX boxside profile at the stated length and height. Verify fit against your specific TANDEMBOX variant, as system generations and accessory compatibility can vary.
A finished interior is the difference between a drawer that looks complete and one that looks assembled. This 22-inch D-height design element in Gray is the part that closes that gap in a TANDEMBOX installation where the inside of the drawer matters as much as the outside.
Sold In: 1 Each