Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice concealed hinge brings Silentia soft-close to inset doors on thick-door frameless and face-frame cabinets, finished in Titanium for a consistent look alongside other visible hardware.
An inset door sits inside the cabinet opening rather than overlapping it, framed by a precise, even reveal on every edge. That look demands tight tolerances and a hinge geometry built specifically for it. This Salice hinge carries the full crank arm that positions an inset door correctly, and its 40mm cup is sized for the heavier door stock found in thick-door cabinet construction, where a standard 35mm cup bores too shallow to seat properly. The 52mm boring pattern supports those thicker doors. The 94 degree opening is not a restriction but the correct engineered angle for this application: a thick door needs that geometry to swing clear of the cabinet front without binding. A separate Salice base plate, ordered separately, mounts to the cabinet and receives the hinge arm.
The hinge is steel with a Titanium finish, a warm, brushed tone that reads well alongside satin brass, champagne bronze, and other transitional hardware finishes. On inset work, where the hinge is sometimes partially visible at the door edge, a finished hinge matters more than it does on a fully concealed install. The Silentia soft-close is integrated into the hinge body, so no separate damper is needed and the mechanism stays protected inside the arm. Height and side adjustment lets the installer dial in the reveal after the cabinet is loaded, so the tight tolerances that inset work demands are achievable in the field without shimming or refitting.
Specify this hinge when the design calls for flush inset doors on thick-door frameless or face-frame cabinets and the hardware finish needs to coordinate across the run. It suits cabinet shops building furniture-grade work, designers specifying a consistent finish palette, and installers fitting premium cabinetry where a quiet, precise close is expected. The screw-on mounting is the right choice where the cabinet side has no pre-drilled system holes or where a fixed mechanical connection is preferred over a tool-free plate. For doors in the standard 16 to 22mm thickness range, a standard 35mm cup hinge is the correct pick instead of this thick-door model.
Thick-door cabinet construction uses heavier door stock that requires a deeper, larger cup. A standard 35mm cup does not seat correctly in those doors. The 40mm cup and 52mm boring pattern on this hinge are sized for that thicker material.
Yes. The 94 degree angle is the engineered opening for thick doors, where the door geometry needs a tighter swing to clear the cabinet front cleanly. It provides full practical access to the cabinet interior.
Yes. This hinge connects to a Salice base plate that mounts to the cabinet, and the plate is a separate purchase. Use a Salice plate matched to your cabinet construction. Plates from other brands will not connect to this hinge.
Yes. This hinge is rated for both frameless and face-frame cabinet types, so the same Titanium finish carries through either construction style.
Choose this hinge when thick-door inset cabinets call for a quiet close, a flush result, and a Titanium finish that holds its place in the hardware palette across the whole job.
Sold In: 1 Each
