Quickscrews #6 x 1-1/2" Modified Pan Head Face Frame and Pocket-Hole Screw Square Drive - Double Auger Point Hi-Lo Plain, 5215 - 7000/Box

A Pocket-Hole and Face Frame Screw Sized for Softwood and Sheet-Good Cabinets

The Quickscrews #6 x 1-1/2" face frame and pocket-hole screw is a coarse-thread fastener built for cabinet face frame joinery and pocket-hole assembly in softwood, pine, plywood, MDF, and particleboard. The modified pan head pulls joints flush without splitting narrow stock, and the double auger point starts fast and clears chips as it drives.

Key Features

• Modified pan head provides a broad, flat bearing surface that draws the joint tight without wedging or splitting face frame stock.
• Hi-Lo thread alternates high and low thread profiles to reduce driving torque and increase pull-out resistance in low-density materials.
• Double auger point uses two opposing flutes for faster chip clearing and cleaner penetration in softwood and engineered panels.
• #2 square drive is designed to hold the screw on a correctly sized bit for one-handed placement in tight pocket-hole positions.
• Coarse thread pitch is matched to softwood, plywood, MDF, and particleboard for strong holding power in engineered cabinet materials.
• 7,000 screws per box keeps a production cabinet shop supplied through extended face frame and carcass runs.

Where This Screw Fits in Cabinet Work

At 1-1/2 inches, this screw is sized for 3/4-inch face frame stock joined with pocket holes, and for attaching assembled face frames to cabinet boxes of similar thickness. The coarse Hi-Lo thread is the right choice for softwood species like pine and poplar, and for sheet goods including plywood, MDF, and melamine-faced particleboard. The modified pan head seats flat against the pocket wall and pulls the joint closed cleanly, which matters on the face side of a cabinet where a rough or raised head shows through finish or veneer.

This is not the right screw for hardwood maple, oak, cherry, or walnut face frames. Coarse thread in tight-grained hardwood risks splitting the stile. For hardwood face frame work, a fine-thread screw is the correct choice.

The Double Auger Point and Hi-Lo Thread at Work

The double auger point carries two opposing flute channels that displace and eject material simultaneously as the screw enters the wood. In softwood and engineered panels, this means the screw starts without wandering and drives with less resistance than a single-flute point. The Hi-Lo thread alternates a tall, sharp high thread with a shorter low thread between each pass. The high thread cuts deep for withdrawal resistance; the low thread stabilizes the shank between passes and reduces the radial pressure that causes fiber tear-out in particleboard and MDF edges.

Together, these two features make the screw fast to drive and reliable in the materials cabinet shops use most for carcass and face frame construction.

Built for Shop Volume

A box of 7,000 screws suits shops that run face frames daily. The #2 square drive minimizes cam-out during repetitive driving with a power tool, which reduces stripped heads and wasted screws over a long production run. The plain finish keeps cost down for interior cabinet applications where a decorative or corrosion-resistant coating adds no practical value.

This screw works equally well for the small shop running custom kitchen cabinets and the mid-size operation building production face frames on a consistent schedule.

Common Questions

The Right Screw Keeps Face Frames Moving

When the material is softwood, plywood, or engineered sheet goods, this Quickscrews #6 x 1-1/2" modified pan head screw brings the right thread, point, and head geometry together for clean, consistent face frame and pocket-hole joints at production volume.