Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #6 x 1-1/4" face frame and pocket-hole screw is built specifically for hardwood face frame joinery. The 1-1/4" length matches the standard pocket-hole specification for 3/4-inch stock, and the fine thread grips tight-grained hardwoods without the splitting risk that coarse threads introduce in maple, oak, cherry, and similar species.
When pocket-hole joinery is used to build or attach a face frame, screw length is not incidental — it determines whether the joint closes cleanly or the tip blows through. At 1-1/4", this screw lands in the correct engagement zone for 3/4-inch stock: enough thread in the second member to pull the joint tight, not so long that the tip risks breaking the far face. The fine thread amplifies that holding power in hardwoods by providing more thread-to-fiber contact than a coarse thread at the same gauge. Cabinet shops building frames in hard maple or oak will find this length and thread combination is the one Kreg specifies for that stock thickness.
The modified pan head on this screw has a broad, flat bearing surface that distributes clamping load across the pocket wall as the joint draws together. Unlike a bugle or countersunk head — which act as wedges in face frame stock — the pan head pulls without splitting. The #2 square drive recess is designed to hold the screw on a correctly sized bit, which matters when reaching into a cabinet box or positioning a joint overhead. The Type 17 Auger point starts the screw quickly in dense hardwood and clears chips as it drives, keeping torque manageable across a full day of assembly.
This is the screw for hardwood face frame construction: rail-to-stile joints on frames built from maple, oak, cherry, walnut, or hickory, and face-frame-to-box attachment where the stock is 3/4-inch hardwood or hardwood plywood. It also suits drawer box assembly and light cabinet interior work where fine-thread grip is an advantage over coarse thread. Because the finish is zinc, keep it to dry interior applications — it is not rated for outdoor or high-humidity environments. Shops running production face frame work will appreciate the 1200-piece box count, which keeps the supply at the bench across a full project run.
Fine thread is the correct choice for hardwood face frames. In tight-grained species like maple, oak, and cherry, a coarse thread applies more radial pressure as it drives, which increases the risk of splitting the stile or rail near the pocket. Fine thread engages more thread surfaces per inch, providing strong pull-out resistance with less splitting pressure.
It is the standard length for 3/4-inch stock joined with a pocket-hole jig. For thicker material — 1-inch or 1-1/2-inch stock — a longer screw is needed to reach adequate thread engagement in the second member. Check the Kreg screw selection chart for the pocket depth and material thickness you are working with.
Yes. The 1-1/4" length and modified pan head work well for pocket-driven face-frame-to-box attachment when the box panel is 3/4-inch material. The pan head pulls the joint tight without splitting the face frame stock at the edge.
A #2 square drive bit. The square recess is designed to hold the screw on a correctly sized bit for controlled one-handed placement in tight spaces, though the fit depends on using a properly sized bit.
It will work in softwood, but a coarse-thread pocket-hole screw is the better choice there — coarse threads pull out more resistance in low-density materials like pine, poplar, MDF, and particleboard. Use the fine-thread version when the face frame is a tight-grained hardwood species.
When the job calls for 3/4-inch hardwood face frames joined with pocket holes, this Kreg #6 x 1-1/4" fine-thread screw is the specified match — correct length, correct thread, correct head, and a drive designed to hold in confined cabinet spaces.
Sold In: 1 Box