Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-10 Series 12 inch side-mount ball bearing drawer slide is built from 304 stainless steel and rated 599 lb per pair, designed for installations where a zinc-finished slide would fail: wet environments, food-service prep areas, marine applications, and anywhere corrosion is a real concern. Full extension brings the entire drawer clear of the cabinet face, and the hold-in anti-rebound detent keeps it closed under vibration or heavy use.
Zinc-finished slides are the right choice for dry indoor cabinetry. But in a commercial kitchen, a marine galley, a laboratory, a medical cart, or any drawer that gets cleaned with water or chemical agents, zinc corrodes and the finish breaks down. The ESR-10's 304 stainless steel members are matched to those conditions from the start. The hold-in anti-rebound detent is particularly useful in these settings: a service drawer on a prep line or a storage compartment on a boat needs to stay shut when the environment is active. The detent catches the drawer on close and holds it until the user pulls it open intentionally — no bounce-back, no drift.
304 stainless steel is the standard alloy for food-contact and washdown hardware, chosen for its resistance to oxidation and cleaning agents in non-marine-saltwater environments. The slide members are formed steel with ball bearings running in continuous raceways — the same telescopic architecture as standard side-mount ball bearing slides, but built to a higher material specification and rated to a significantly higher load class. The stainless finish is functional and consistent with the material itself, not a plating over a different substrate.
The ESR-10 in 12 inches suits shorter drawers in demanding settings: undercounter pull-outs in commercial kitchens, equipment drawers on medical or laboratory carts, compartment drawers in marine cabinetry, and utility applications where load, cleanliness, and corrosion resistance all matter. At 599 lb per pair, it also serves heavy industrial drawers where a standard cabinet slide would be undersized. Cabinet shops and contractors specifying for commercial or institutional projects will find it a reliable answer when the environment rules out standard finishes.
304 stainless performs well in freshwater and general marine interior environments, but 316 stainless is the preferred alloy for direct saltwater exposure. If the installation is in a saltwater-splash zone or on a working boat deck, confirm whether 316 is required for your application.
It is a mechanical catch that holds the drawer in the closed position and prevents it from bouncing back open after a firm close. It does not pull the drawer shut on its own and it does not damp the closing action — the drawer stays where you push it.
Side clearance for the ESR-10 series is not confirmed in the available source data. Standard side-mount ball bearing slides in this segment require nominally 1/2 inch per side, but verify the ESR-10's specific clearance requirement against the Sugatsune installation sheet before sizing the drawer box.
No. The ESR-10 is non-handed, so both slides in the pair are identical. Order one pair per drawer.
No — 12 inches is the closed length of the slide. Because this is a full-extension slide, the drawer travels approximately the full slide length and the entire drawer clears the cabinet face at full open. Slide length and travel are separate specs.
When the environment demands stainless and the load demands real capacity, the Sugatsune ESR-10 delivers both in a side-mount format that installs like any standard ball bearing slide.
