Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series tambour door covers a 36-inch-wide opening in solid maple, rolling along a track to conceal an appliance garage while keeping countertop appliances within reach. It ships unfinished so it can be stained or painted to match the surrounding cabinetry.
Appliance garages are most useful when the door blends into the surrounding cabinetry rather than reading as an afterthought. A solid maple panel gives the finisher a consistent surface to work with: the grain takes stain evenly, the wood holds paint without the telegraphing that can appear on veneer edges, and the finished result reads as part of the cabinet run. The 36-inch width and 47-inch length address the wider, taller garage openings found in kitchens where the appliance garage spans an under-cabinet section from countertop to wall cabinet bottom. Narrower panels in the SW Series cover smaller openings; this size is the right call when the opening is genuinely wide.
The door is built from solid maple in the SW Series, cut and assembled with a half round edge profile on each slat. That profile creates a gently rounded surface between slats, a detail that reads as intentional joinery rather than a flat panel scored into strips. Because the panel arrives unfinished, the shop or installer controls the final color. Maple's tight, consistent grain works well under both stain and paint, though maple can be selective about how it accepts pigmented stains — a pre-conditioner or a gel stain helps when a uniform color is the goal. The track and hardware needed to install this door are sold separately; confirm compatibility with the track system before ordering.
Cabinet shops building custom appliance garages in wider kitchen runs are the primary buyers here. A 36-inch-wide garage can house a stand mixer, a toaster oven, and a coffee maker side by side, and the 47-inch length clears the taller clearances those configurations require. Designers specifying an appliance garage to match an existing painted or stained maple kitchen will find the unfinished panel straightforward to match. Contractors replacing a worn tambour panel on an existing garage should confirm the opening dimensions and track spacing against this panel's specs before ordering.
No. The track, guides, and mounting hardware are sold separately. Confirm that your track system is compatible with this panel's width and slat thickness before ordering.
Solid wood tambour panels can be trimmed, but cutting the panel affects the slat count and the edge slats, and the cut edges will need to be refinished. For a precise fit, it is usually better to select the panel size closest to the opening rather than cutting down a larger one.
Maple accepts stain, paint, and clear coat. For pigmented stains, a pre-conditioner or gel stain helps produce a more even result, since maple's density can cause blotching with some liquid stains. For a painted finish, prime and sand before topcoating.
No. The CO2 Series is a separate line offered in thinner solid wood and veneer options at narrower widths. This SW Series panel is solid maple at 5/16-inch thickness and covers the larger 36-inch-wide by 47-inch-tall opening.
This panel brings a 36-inch appliance garage opening under a clean, matchable maple surface — ready to finish on your schedule, in the stain or paint the project calls for.
Sold In: 1 Each