Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series tambour door brings a flexible, ready-to-finish solid maple panel to appliance garages, cabinet enclosures, and other cabinetry that calls for a rolling door. At 95 inches long and 12 inches wide, it covers taller or custom-height openings where standard shorter panels fall short.
Most tambour doors in this family top out at 47 or 60 inches. This 95-inch panel is the reach-extender: it suits a full-height appliance garage, a floor-to-ceiling enclosure panel, or any custom build where the opening runs taller than a standard upper-cabinet height. Cabinet shops cutting custom openings and designers planning integrated cabinetry from countertop to ceiling will find this length covers the job without splicing two shorter panels together. The 12-inch width keeps it in the range of a single appliance bay or a narrow column enclosure.
The panel is milled from solid maple, not a veneer, so the slats carry the same wood through the full thickness. Maple's tight, consistent grain and pale color make it equally receptive to a clear natural finish and to opaque paint, which is why it is a common choice when the surrounding cabinetry is a painted finish or a light stain. The half round edge on each slat is a traditional profile: the rounded face breaks up the surface with a gentle ridge line rather than a flat, uniform face. The panel ships unfinished, ready to receive whatever topcoat the project calls for before installation.
This door is a fit for custom cabinet builders and kitchen designers working on a tall enclosure where an off-the-shelf shorter panel is not enough. Homeowners doing a custom appliance garage remodel who need a specific full-height panel will also find the unfinished state useful, since it lets them match the stain or paint of the surrounding cabinetry precisely. Track, mounting hardware, and any associated tambour hardware are sold separately; plan the track system before ordering to confirm the panel will clear the required radius.
No. This is the door panel only. Tambour track, hardware packs, and mounting components are sold separately. Confirm the track system you are using before ordering to make sure the panel thickness and edge profile are compatible.
Solid maple. The slats are cut from solid wood, not a veneer over a substrate, so the wood runs through the full 5/16-inch thickness.
Tambour panels can typically be trimmed, but the cut must be clean and the slat backing must be accounted for. Consult your shop's standard tambour-cutting practice before trimming.
The panel arrives unfinished and bare. Apply stain, paint, or clear coat before installation so the finish can reach all faces of the slats. Finishing after the door is in the track is difficult and leaves the slat edges exposed.
When the opening is taller than a standard appliance garage and the project calls for a solid wood tambour door that finishes to match surrounding cabinetry, this 95-inch maple panel with a half round edge profile is the right starting point.
Sold In: 1 Each