Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series tambour door is a solid red oak flexible panel with a half round slat edge profile, supplied unfinished and sized at 95 inches long by 12 inches wide to suit tall or custom-sized appliance garage and cabinet openings.
Appliance garages with a taller than standard opening, custom cabinetry with a long vertical run, and projects where the installer needs to cut the panel to a precise height all benefit from starting with a longer blank. At 95 inches, this panel gives a cabinet shop or finish carpenter enough material to fit a range of opening heights from a single piece, rather than piecing together shorter panels. The 12-inch width suits narrower openings and is a common fit for single-appliance garages on a countertop run.
The track and hardware needed to mount a tambour door are sold separately. Size the tambour track to match the opening and the panel width before ordering.
Red oak is a domestic hardwood with a pronounced open grain and a warm, reddish-tan tone that takes stain readily and finishes consistently across the slat faces. Because this panel is solid wood rather than a veneer over a substrate, the grain runs through the full slat thickness, so trimming the length does not expose a raw core or a different material at the cut edge. The half round profile on each slat edge reads as a traditional detail, well suited to raised-panel or classic shaker cabinetry where a flat-edge profile would look too plain. The unfinished state means the door can be stained to match existing cabinet doors before installation, which is the standard approach for a matched kitchen.
Cabinet shops building custom appliance garages with taller openings reach for this SKU when the standard 47-inch and 60-inch panels in the SW Series fall short of the required height. Finish carpenters on a remodel with an existing tall opening, designers specifying a half round profile to complement traditional millwork, and millwork dealers stocking the full SW Series width in red oak are the primary buyers. Homeowners tackling a DIY garage build who want real hardwood and a traditional slat profile rather than a painted flat-edge option will find the same fit here.
Yes. Because the slats are solid red oak, trimming the panel to a shorter length leaves a clean wood edge with no exposed substrate or core. Cut from whichever end suits the installation.
The half round profile has a gently curved top edge on each slat, which reads as a traditional furniture detail. The flat edge profile has a square slat top for a cleaner, more contemporary line. Both are available in red oak within the SW Series.
No. The tambour track, guide hardware, and any mounting components are sold separately. Match the track to the panel width and the cabinet opening dimensions when ordering.
No. It ships unfinished so it can be stained, painted, or clear-coated to match the surrounding cabinetry before installation.
When a standard-length tambour panel falls short, this 95-inch solid red oak door in a half round profile gives the project a hardwood blank long enough to fit, finish, and trim to the exact opening required.
Sold In: 1 Each