Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series solid maple tambour door is a ready-to-finish panel for appliance garages and similar cabinet openings, designed for shops and installers who want to stain or paint to an exact match with surrounding cabinetry.
An appliance garage keeps countertop appliances out of sight behind a door that rolls up and out of the way rather than swinging open into the work zone. This tambour door is the moving face of that enclosure. Because it arrives unfinished, it goes onto the job site as raw wood and leaves with the same stain, paint, or clear coat as the cabinet run around it. That is the practical reason a shop specifies solid maple here: the wood takes finish predictably, the grain is tight, and the result reads as part of the kitchen rather than a separate component.
The SW Series uses solid maple throughout, not a veneer panel over a substrate. Each slat in the door is real maple wood, which means the edge of every slat, the face, and any trimmed end all present the same material. The flat edge profile is the straightforward choice for contemporary and transitional kitchens where a rounded or decorative edge profile would compete with simple door and drawer fronts nearby. The panel ships unfinished, so the first step after delivery is sanding to the desired grit, then finishing to spec. Track hardware and the appliance garage enclosure are sold separately.
Cabinet shops building custom kitchens reach for this door when a client wants continuity across the full room and the appliance garage finish needs to be dialed in rather than accepted as-is. Designers specifying a project with a particular stain sample in hand will find solid maple easier to match than a pre-finished or veneer option. For a production run of appliance garages across multiple units, the consistent grain and density of maple make finishing more predictable from unit to unit. This door is for indoor cabinet applications only.
No. This SKU is the tambour door panel only. The tambour track, guide hardware, and appliance garage enclosure are sold separately and must be matched to the opening dimensions.
Solid wood tambour panels can typically be trimmed in width to fit a narrower opening, but the cut end will need to be finished to match the face. Confirm the required dimensions and check that the cut falls within the slat pattern before trimming.
Because it arrives unfinished, the panel accepts stains, paints, and clear topcoats. Maple takes pigmented stains well when a pre-conditioner is used to even out grain absorption, which is standard practice for paint-grade and matched-stain applications.
Yes. Solid wood slats show the same material on the face, edge, and any trimmed end. A veneer panel uses a thin wood face over a different substrate, which can show at cut edges. Solid is the better choice when edge exposure is part of the install.
Specify this solid maple tambour door when the appliance garage needs to finish out as part of the kitchen, not as an afterthought, and the finishing is being done in-shop to a specific color or sheen.
Sold In: 1 Each