Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the 22 inch drawer member from Knape and Vogt's 8400 series, the individual inner rail that mounts to the drawer box in a full-extension, 100 lb rated side-mount ball bearing installation. Zinc-finished and non-handed, it arrives in a bulk pack sized for cabinet shops running production quantities.
A side-mount ball bearing slide is made up of two components: a cabinet member that screws to the interior cabinet side, and this drawer member that attaches to the drawer box side. This SKU is the drawer member only. Pair it with the matching 8400 series cabinet member to complete a working slide set. The 22 inch nominal length suits drawer boxes built to standard kitchen and utility depths; the slide travels the full length of the member, bringing the drawer completely clear of the face. Build the drawer box 1 inch narrower than the cabinet opening to allow 1/2 inch of side clearance per slide.
Zinc plating is the right call for a slide that will be installed, used, and forgotten about. It protects the cold-formed steel against the humidity and contact wear of daily indoor service without adding cost or visual weight to a component that sits largely out of sight beside the open drawer box. Zinc is not a decorative finish and is not rated for wet or outdoor environments. For shop builds, office cabinetry, and residential kitchens, it is exactly what the application calls for.
The 8400 series drawer member is the workhorse choice for cabinet shops building in volume: kitchens, office credenzas, utility cabinets, and garage storage where the 100 lb rating covers everyday loads and full extension keeps every drawer fully accessible. The hold-in anti-rebound detent makes it a natural fit for drawers that see heavy daily use and need to stay shut reliably. Because the design is non-handed, a single production pack covers every drawer in the shop regardless of which side of the box it goes on. In face-frame installations, add the matching rear mounting brackets, sold separately, to support the back end of the slide.
This is the drawer member only — the inner rail that attaches to the drawer box side. You also need the matching 8400 series cabinet member to build a working slide. Order both components, one set per drawer.
A mechanical detent catches the drawer when it is pushed closed, keeping it seated and stopping it from springing back open. There is no spring assist and no damper — the drawer stays where you push it until you pull it open again.
The 22 inch figure is the closed slide length, not a travel measurement. Full extension means the drawer member travels approximately the full slide length, clearing the drawer box out to the cabinet face. Measure your cabinet interior depth to confirm the 22 inch length is the right fit.
No. The 8400 series drawer member is non-handed — one part fits either side of the drawer box, so the same part number covers both slides in a drawer installation.
Yes, but face-frame construction requires rear mounting brackets to support the back of the slide because the cabinet side is set back from the frame face. Those brackets are sold separately and are series-specific to the 8400 line.
When the job calls for consistent full-extension performance at the 100 lb class across a full kitchen or a run of office drawers, this zinc 8400 series drawer member delivers it in a bulk pack built for the way production shops actually order.
Sold In: 100 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 100 Each |  KV8400Q90-22 Mfr# 8400-90 22 | KV 8400 20-Pair Box 22" Hold-In/Anti-Rebound Side Mount Full Extension 100 lb Ball Bearing Drawer Slide, Zinc, 8400-90 22 |
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  KV8402 Mfr# 8402 | KV 8400 Rear Mounting Bracket, Zinc, 8402 |
