Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the right-hand rear mounting bracket with socket for Grass Elite Plus drawer slides, the component that anchors the back of the slide to a face-frame cabinet so the Elite Plus system installs correctly where the cabinet side is set back from the front frame.
In a frameless cabinet, an Elite Plus slide screws straight to the flat interior side panel and the rear end rests naturally against the cabinet back. A face-frame cabinet works differently: the cabinet side is recessed behind the face frame, leaving the slide's rear end without a flat panel to rest against at the right height and depth. This bracket solves that problem. It mounts at the rear of the cabinet and holds the back of the slide at the correct height and alignment, so the slide runs parallel to the drawer opening even when the side panel geometry does not cooperate. Without a matched rear bracket, the slide tips down at the back, the drawer binds or sits crooked, and the front-adjustment range on the locking device cannot fully correct the problem.
The bracket is metal, finished to suit the Elite Plus program's interior hardware. The V-notch registers the slide body positively rather than relying on friction or set screws, and the integrated socket eliminates a separate retention clip. Screw-on mounting keeps installation straightforward: position the bracket at the correct rear height, drive the screws, and drop the slide into the socket.
This bracket is the part face-frame cabinet builders most commonly forget to add to their Elite Plus slide order. If you are specifying Elite Plus slides for any face-frame application — traditional American kitchen cabinetry, furniture pieces with applied frames, or retrofit work in existing framed boxes — you need one right-hand and one left-hand rear bracket per drawer. It is also worth keeping a few on hand when installing Elite Plus slides in production shops where face-frame and frameless cabinets move through the same line: running out of rear brackets mid-install is the most common reason an Elite Plus project stalls.
No. This bracket is designed for the Elite Plus series. Grass rear brackets and sockets are series-specific; a bracket from another Grass program will not align correctly with Elite Plus slides.
Yes — one right-hand and one left-hand bracket per drawer opening. The rear bracket supports both sides of the slide pair, so a single drawer requires a matched set of two brackets.
Generally no. In a frameless cabinet the slide's rear end rests against the flat back panel and the side panels provide full support along the slide's length. Rear brackets are the face-frame solution.
The socket captures the rear end of the slide and holds it in position so it cannot lift or shift during operation. A plain bracket supports the slide from below; the socket retains it from all sides at the rear, which matters under load on heavier drawers.
Order the right-hand and left-hand rear brackets alongside your Elite Plus slides and your face-frame installation goes in correctly on the first trip — no return visits to add the hardware that was missing from the original order.
Sold In: 1 Each
