KV6400 18" Full Extension Hold-in anti-rebound Ball Bearing Drawer Slides, Unhanded Side Mount Stainless Steel Poly-Pack - 6400P SS 18

Stainless Steel Ball Bearing Drawer Slides for Demanding Indoor Environments

The Knape and Vogt 6400 Series is an 18 inch full-extension side-mount ball bearing drawer slide in a Stainless Steel finish, rated 75 lb per pair. Where most cabinet slides wear a standard zinc coating, this one steps up to a stainless steel finish built to resist moisture and corrosion — making it the right call for utility rooms, kitchens, workshops, and anywhere humidity or cleaning products put ordinary finishes to the test.

Key Features

• Stainless Steel finish — resists corrosion and holds up in humid or damp indoor environments where a standard zinc slide would struggle.
• Full extension — the entire drawer clears the cabinet opening, putting the back of the drawer fully within reach.
• Hold-in anti-rebound detent — a mechanical catch keeps the drawer closed when pushed shut, preventing it from bouncing back open.
• 75 lb load rating per pair — covers a well-loaded kitchen, bath, or utility drawer without overrating the application.
• Non-handed design — one slide fits either side of the drawer, cutting sorting time on the bench.
• 1/2 inch side clearance — the standard side-mount clearance, compatible with typical drawer box sizing formulas.

Where This Slide Earns Its Finish

A stainless finish matters most in spaces where drawers get wiped down regularly, moisture lingers, or cleaning chemicals are part of the routine. Think cabinet runs beneath a laundry sink, shop drawers in a garage with fluctuating humidity, bath vanities in a steam-prone environment, or utility cabinetry in a commercial break room. The hold-in anti-rebound detent adds practical value in the same settings: in a drawer that gets closed with a loaded hand rather than a careful push, a detent that stops bounce-back is worth having. This is a standard-motion slide — no soft-close damper and no spring assist — so the drawer stays wherever it is left until intentionally pushed shut, at which point the detent holds it there.

Construction and Finish Details

Steel members with a Stainless Steel finish give this slide its corrosion-resistant edge over zinc-plated equivalents. The ball bearings run in full-length raceways for smooth, consistent travel under load. At 18 inches nominal length, the slide fits a standard cabinet drawer depth; the full-extension three-member design includes an intermediate member that carries the drawer member the full length of the slide so the drawer clears the opening completely. This is an indoor slide — it is built for damp or moisture-prone environments inside, not for exterior or washdown applications.

Who Should Choose the 6400 Series Stainless

Cabinet shops and contractors specifying kitchen, bath, or utility work where the hardware finish needs to match a corrosion-resistant standard will find the 6400 Series Stainless a practical step up from the zinc version without changing the installation routine. Homeowners renovating a laundry room or a high-humidity bath cabinet get a slide that holds up to the environment. The 75 lb per-pair rating covers most residential and light commercial drawer loads at this length; if the application calls for more capacity, size up to the 150 lb class before building. Sold as a poly-pack pair — one pair arrives per package, ready to install.

The Right Slide for Environments That Test Ordinary Hardware

When the drawer location calls for a finish that holds up to moisture and regular cleaning, the Knape and Vogt 6400 Series Stainless delivers full extension, a stay-closed detent, and a corrosion-resistant finish in the familiar 1/2 inch side-mount format — the same reliable installation as any standard ball bearing slide, built for tougher conditions.