Würth #6 x 5/8" Flat Head Hinge and Drawer Slide Installation Screw Combo Drive - Sharp Point Coarse Thread Zinc, 367000028896115000 - 15000/Box

Zinc Hinge and Drawer Slide Installation Screw for Tight Mounting Positions

The Würth #6 x 5/8-inch flat head hinge and drawer slide installation screw is built for mounting European cup hinges, side-mount drawer slides, and other cabinet hardware directly to panel surfaces. The 5/8-inch length seats hardware plates without over-penetrating standard 3/4-inch cabinet stock, and the combo drive accepts either a #2 Phillips or a #2 square bit so installers can work with whatever is already on the tool.

Key Features

• 5/8-inch length sized to mount hardware plates to 3/4-inch cabinet panels without punching through to the finished face.
• Flat head profile seats flush against hardware mounting plates for a clean, secure fit.
• Combo drive accepts a #2 Phillips or a #2 square bit in the same recess, reducing bit changes on the job.
• Coarse thread with a sharp point for fast starts and solid grip in wood-based cabinet panels.
• Zinc finish suited to dry interior cabinet environments.
• 15,000 per box keeps a production shop stocked through extended runs of hinge and slide installation.

Where the 5/8-Inch Length Fits

Hinge cup plates, clip-on hinge bases, and drawer slide mounting clips are all designed around a short fastener that pulls the plate tight without reaching the visible face of the panel. At 5/8 inch, this screw hits that target in standard 3/4-inch sheet goods, particleboard, and MDF cabinet sides. It is the right call any time the hardware spec sheet calls for a #6 x 5/8-inch screw, and it also covers drawer slide clips on 1/2-inch drawer box sides where a longer screw would exit the opposite face.

Combo Drive and Flat Head in Practice

The combo recess accepts both a #2 Phillips and a #2 square bit. On a production line where one installer runs a square-drive bit and another uses Phillips, both can drive the same screw without a box change. The flat head bears evenly against the mounting plate, keeping the hardware pulled tight and seated squarely. Coarse threads engage quickly in the low-density substrates common in frameless cabinet construction, including particleboard and melamine-faced panels.

Who This Screw Is For

Cabinet shops running European frameless lines or face-frame cabinets with concealed hinges will go through hardware mounting screws in volume. At 15,000 to the box, this SKU is sized for that reality. It also suits millwork installers and finish carpenters who install pre-built cabinets on site and need a reliable supply of the correct mounting screw rather than pulling mismatched lengths from a general-purpose assortment. The zinc finish keeps it appropriate for the dry, enclosed environment inside a cabinet box.

Common Questions

The Right Screw Already on the Bit

Consistent hardware installation comes down to using the correct fastener every time. This Würth #6 x 5/8-inch combo-drive hinge and drawer slide screw puts the right length, head, and thread on the shelf so installation runs without interruption.