Würth #7 x 1-1/4" Modified Pan Head Face Frame and Pocket-Hole Screw Square Drive - Type 17 Auger Point Coarse Thread Lubricated, 3670000193961 1000 - 1000/Box

1-1/4 Inch Face Frame and Pocket-Hole Screw For 3/4-Inch Softwood Stock

The Würth #7 x 1-1/4" Modified Pan Head Face Frame and Pocket-Hole Screw is sized for the most common joint in cabinet face-frame construction: two pieces of 3/4-inch softwood or sheet-good stock pulled tight at a pocket-hole angle. A lubricated coarse thread, Type 17 Auger point, and #2 square drive make this screw a capable daily driver for cabinet shops building pine, poplar, or plywood frames at volume.

Key Features

• 1-1/4-inch length is the standard sizing for pocket-hole joints in 3/4-inch softwood, plywood, and MDF stock.
• Modified pan head bears flat against the pocket wall for a tight, stable joint without burying into the material.
• #2 square drive is designed to hold the screw on a correctly sized bit for controlled one-handed placement in tight cabinet interiors.
• Type 17 Auger point uses a fluted tip to clear wood fibers as it starts, reducing driving torque and splitting risk.
• Coarse thread provides strong pull-out resistance in softwoods, plywood, MDF, and particleboard.
• Lubricated finish lowers friction during installation, making repeated driving faster and easier in production runs.

The Right Screw for 3/4-Inch Stock Face-Frame Joinery

Face-frame work puts specific demands on a fastener. The head needs to bear cleanly against the pocket without wedging or splitting the stock, the thread needs to grip the far piece firmly, and the length needs to be matched to the material thickness. At 1-1/4 inches, this screw is built precisely for 3/4-inch softwood, plywood, and MDF joints. It drives through the angled pocket bore and pulls the two workpieces together cleanly, whether you are assembling rail-to-stile joints in a batch of cabinet frames or attaching a finished face frame to a cabinet box. Coarse thread handles the fibrous structure of pine, poplar, and sheet goods well, and the Type 17 Auger point reduces splitting risk when driving close to an edge.

Lubricated Finish and a Drive Built for Volume Work

The lubricated coating on this screw lowers the friction the driver has to overcome on every single pass. In a shop building dozens of face frames a day, that reduced resistance adds up to less fatigue, fewer stripped heads, and faster cycle times. The #2 square drive recess is designed to hold the screw on a correctly sized bit for one-handed placement, which matters when you are reaching into a cabinet box or working with a jig in a fixed position. Pair it with a Würth square drive bit for the fit the recess is designed around.

Cabinet Shops and Contractors Building Softwood Frames

This screw fits best in shops and on job sites where the face frames are pine, poplar, or a sheet good such as plywood, MDF, or particleboard. The coarse thread is calibrated for those lower-density materials. For hardwood face frames in maple, oak, or cherry, a fine-thread face-frame screw is the better match because coarse threads can stress-crack tight-grained hardwood at the joint. A 1000-piece box supports steady production without frequent reordering, and the lubricated finish keeps things moving shift after shift.

Common Questions

Keep Production Moving Frame After Frame

When the job is building face frames in 3/4-inch softwood or sheet goods and you need a screw that starts clean, seats flat, and holds the joint, this is the one to reach for. The 1000-piece box keeps the bin full through a long production run.