Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #8 x 1 inch drawer front adjusting screw gives cabinetmakers and installers a dedicated fastener for attaching and aligning drawer fronts to drawer boxes. The modified washer head, Phillips drive, and Type 17 Auger point work together to seat cleanly in standard drawer front hardware slots without over-penetrating thin stock.
At 1 inch, this screw is sized for attaching drawer fronts through the drawer box face using standard adjusting hardware. The length provides enough thread engagement in the drawer box wall without pushing through the back face of thinner stock. This is the go-to length when the drawer box front is 3/4 inch material and the adjusting clip or slot requires minimal standoff. For thicker drawer box fronts or applications with additional material between the clip and the wood, the family is also available in longer lengths.
The modified washer head is the detail that makes this a proper drawer front adjusting screw rather than a generic fastener. The wider bearing surface holds the screw in the elongated slot of the adjusting clip so the front can be shifted laterally or vertically before final tightening. Once position is dialed in, the head locks the clip in place without deforming the slot. The #2 Phillips drive is standard across most shop and jobsite setups, so no bit swap is needed.
Cabinet shops running production work and finish carpenters hanging kitchen or bath drawers both reach for this screw when drawer front alignment matters. The Type 17 Auger point handles plywood and MDF drawer box construction without pre-drilling in most cases. The zinc finish is appropriate for the dry, climate-controlled interior of a finished cabinet. This is a shop staple rather than a specialty item, and the 100-piece box quantity reflects that.
The modified washer head has a wider, flatter bearing surface that spans the elongated adjustment slot in the drawer front clip. That wider footprint lets you slide the front into position and clamp it down without the head pulling through the slot or tilting into it.
It is compatible with standard #8 drawer front adjusting clips and elongated-slot hardware common in European-style frameless and face-frame cabinetry. Confirm the clip manufacturer's specified screw gauge and head style before installing.
In most plywood and MDF drawer box stock a pilot hole is not required. In very hard solid wood or when driving very close to an edge, a pilot hole reduces the risk of splitting.
The zinc finish is designed for dry interior use. It is not rated for exterior applications or high-humidity environments such as outdoor kitchens or marine cabinetry.
The 1 inch length is the right choice when driving into standard 3/4 inch drawer box stock through a clip with minimal standoff. Longer lengths in the family suit thicker material or deeper hardware profiles where more thread engagement is needed.
When drawer fronts need to land exactly where they belong, this 1 inch Würth drawer front adjusting screw does the job cleanly, every time, without the guesswork of using a general-purpose fastener in a slot designed for something specific.
Sold In: 100 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 10 Each |  WW92210 Mfr# 0614176261961 10 | #2 x 1" Phillips Drive Insert Bit |
