Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #8 x 1-1/8" Drawer Front Adjusting Screw is built for attaching and fine-tuning drawer fronts on cabinet boxes. The modified washer head seats squarely against the drawer box face and holds a front securely through an elongated slot or adjustment clip, leaving room to shift, align, and lock the front in final position before fully seating the screw.
Drawer front attachment is a two-stage task: the screw first holds the front loosely so it can be nudged into alignment with adjacent doors and drawer fronts, then gets driven home once the gaps are right. The 1-1/8" length suits this workflow across common drawer box constructions. It reaches through the drawer box face and into the backing material or adjustment clip with enough thread engagement to hold the front firmly after final tightening, without punching through the opposite face of a standard plywood or MDF box wall. Cabinet installers hanging production runs of drawer fronts and shop teams assembling frameless cabinetry will find this length consistently useful across the drawer sizes that make up most residential and light commercial work.
The screw is steel with a zinc finish suited to the indoor conditions of installed cabinetry. The modified washer head is wider than a standard pan head, distributing clamping load across the face of the drawer box rather than concentrating it at a small point. That matters when the screw is working through an oversized or elongated adjustment slot, where a narrower head could pull through under load. The Type 17 auger point cuts cleanly into plywood and engineered panels, and the coarse thread holds well in those materials without the spinning-out risk that finer threads can present in lower-density sheet goods.
Production cabinet shops running drawer front installation on frameless or face-frame cabinetry go through drawer front adjusting screws in volume. A box of 1,000 covers a significant run without a mid-project reorder. Installers working on multi-cabinet kitchen or bath projects also benefit from having a full box on hand, since consistent screw length across all the drawer fronts keeps installation rhythm steady. The standard Phillips drive means no special bits are needed, and the screw works with the adjustment hardware already specified in most European-style drawer system installations.
The modified washer head is wider than a pan head, so it spans the full width of an adjustment slot and keeps the drawer front from shifting or pulling the screw through the slot under the weight of the door. It distributes load across the drawer box face rather than concentrating it at a small contact point.
Yes. This length is sized for common drawer box constructions in plywood and MDF. It reaches through the box face and into the adjustment clip or backing material with adequate thread engagement without punching through the opposite face of typical 1/2" or 5/8" drawer box stock.
Not typically. The Type 17 auger point is designed to self-start in plywood, MDF, and particleboard without a pilot hole. The fluted tip clears material as the screw enters, reducing the torque required to seat it and lowering the chance of splitting near the edge of the drawer box face.
This screw attaches the drawer front to the drawer box, not to the face frame itself. That task is the same whether the cabinet is frameless or face-frame construction, so yes, it works in both cabinet types for the drawer front attachment step.
Each box contains 1,000 screws.
When the screw length, head, and point are matched to the job, drawer front installation moves faster and the alignment holds. This Würth #8 x 1-1/8" adjusting screw is that match for standard drawer box stock, giving installers and shop teams a reliable go-to for every drawer front on the project.
Sold In: 1000 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 10 Each |  WW92210 Mfr# 0614176261961 10 | #2 x 1" Phillips Drive Insert Bit |
