Sugatsune ESR-DC 18" Hold-In/Anti-Rebound Side Mount Full Extension 100 lb Ball Bearing Drawer Slide, Stainless Steel, ESR-DC4513-18

18 Inch Full-Extension Stainless Steel Slide for Demanding Environments

This is an 18 inch full-extension side-mount ball bearing drawer slide from Sugatsune's ESR-DC series, made from stainless steel and rated 100 lb per pair. Where zinc or aluminum finishes fall short — wet rooms, food-prep areas, marine cabinetry, and any installation where corrosion is a real concern — the stainless steel construction gives these slides the material advantage the application requires.

Key Features

• Stainless steel construction — material-level corrosion resistance for wet, washdown, and high-humidity environments.
• Full extension — the drawer comes all the way out to the cabinet face, putting the entire interior within reach.
• 100 lb load rating per pair — handles a fully loaded utility or storage drawer within the standard cabinet duty class.
• Hold-in anti-rebound detent — a mechanical catch keeps the drawer closed and stops it from bouncing back open after a firm push.
• Non-handed design — both slides in the pair are identical; no left/right sorting required at installation.
• Ball bearing travel on 1/2 inch side clearance — smooth, consistent movement with the standard side-mount clearance requirement.

Where Stainless Steel Earns Its Place

Most drawer slides are zinc-finished steel — a practical, indoor finish that handles years of normal cabinet service. Stainless steel becomes the right call when the environment is something other than a standard dry interior. A commercial kitchen drawer that gets wiped down with cleaning solutions, a marine galley cabinet that sees salt air, a workshop sink cabinet that collects humidity, a food-service prep station that runs through washdown cycles — these are the places where the base material matters as much as the load rating. The ESR-DC series slides are built from stainless steel throughout, so the corrosion resistance is in the material itself, not a coating that can wear through.

The hold-in anti-rebound detent is worth noting in these same settings. In busy commercial or marine environments, drawers get shut firmly and repeatedly. The detent keeps the drawer positively closed without relying on a spring or damper, and it stops the bounce-back that a hard push can cause on a plain bearing slide.

Materials and Construction

The slide members are stainless steel with a finish to match — a clean, bright appearance that holds up in environments where zinc plating or powder coating would degrade. Ball bearings in full-length raceways carry the load smoothly across the full travel. This is a standard-profile side-mount slide: it sits beside the drawer box, visible when the drawer is open, and requires the same 1/2 inch of side clearance per side as other slides in this class. The non-handed design means a single part number covers both sides of the installation, which simplifies ordering for shops running multiple drawer runs.

Who This Is For

Specifiers and cabinet shops working on commercial kitchens, healthcare millwork, marine cabinetry, or any built-in that lives in a wet or high-humidity space will find the stainless material class a straightforward answer to finish durability questions. At 100 lb per pair and 18 inches, this slide fits the standard utility drawer depth and load range. Homeowners finishing a laundry room or mudroom cabinet who want hardware that handles moisture without rusting out in a few seasons will find the same logic applies. The slide is sold as a pair.

Hardware That Matches the Environment

When the cabinet goes somewhere that makes lesser hardware fail early, specifying stainless steel at the slide level is the straightforward answer. The ESR-DC series delivers 100 lb full-extension performance in a material built for the conditions that matter most.