Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-DC series is a 22 inch full-extension side-mount ball bearing drawer slide made from stainless steel, rated 94 lb per pair, with a hold-in anti-rebound detent that keeps the drawer firmly closed until pulled. This is the slide to reach for when zinc plating is not enough — wet areas, washdown environments, food prep spaces, or anywhere the hardware needs to outlast the finish.
The ESR-DC4513-22 is the right choice when the installation environment works against ordinary finishes. Commercial kitchens, marine cabinetry, lab casework, outdoor BBQ stations with enclosed storage, and any drawer that sees repeated cleaning with liquids all put conventional zinc-plated slides at a disadvantage. Stainless steel holds up where zinc would corrode, pit, or seize. The hold-in anti-rebound detent adds another practical advantage in those same settings: a loaded drawer on an imperfect surface or a rolling cart stays put rather than creeping open.
Both the cabinet member and the drawer member are stainless steel — not a stainless facing over a steel core, but consistent material through the slide. Ball bearings run in full-length raceways for smooth, even travel under load. The stainless finish is a functional surface that reads as clean and professional in exposed installations. Note that stainless steel is specified here for corrosion resistance in indoor and sheltered outdoor environments; confirm suitability for marine or saltwater-immersion applications against the ESR-DC series data before specifying for those conditions.
Cabinet shops building commercial or institutional casework often spec the ESR-DC series when a client's environment rules out zinc or painted slides. Restaurant equipment fabricators and lab furniture builders treat stainless hardware as a baseline requirement, not an upgrade. The non-handed design simplifies inventory — one part number covers left and right, so a shop building a run of drawers orders pairs by count rather than pairs by side. The 94 lb per pair rating handles the typical loads in those environments without stepping into the heavy-duty class.
The slide members are stainless steel material, not a decorative coating over carbon steel. The ESR-DC series is built for environments where corrosion resistance is the reason for the selection.
No. The detent is a mechanical catch that holds the drawer closed and prevents it from bouncing back open after a firm push. There is no spring assist and no damper — the drawer does not pull itself shut, and there is no slow-close action. It simply stays where you put it.
22 inches is the closed length of the slide. Because this is a full-extension slide, the drawer member travels approximately the full slide length, bringing the entire drawer clear of the cabinet face. Slide length and drawer travel are two separate specs; this slide's full-extension design means they are very close to each other.
No. The ESR-DC4513-22 is non-handed, so the same slide fits either side of the drawer. Order one pair per drawer.
Side-mount slides need support at the rear of the cabinet in face-frame construction. Add the appropriate rear mounting brackets for face-frame installs — brackets are series-specific and sold separately. The slide mounts directly in frameless cabinets using the standard side-panel holes.
When the build calls for hardware that stands up to moisture, cleaning cycles, or demanding commercial conditions, the Sugatsune ESR-DC4513-22 delivers full-extension access and a 94 lb rating in a material that belongs in those spaces — sold as a pair, ready to install.
Sold In: 1 Pair
