Wide-Swing Geometry And Thick-Door Fit

This Salice Series 200 hinge is built for thick cabinet doors that need a wider-than-standard swing, hanging them at a 1/2 inch overlay on both face-frame and frameless cabinets with a self-close spring mechanism.

Key Features

• 155 degree opening angle swings the door nearly flat for unobstructed access inside the cabinet.
• Thick-door engineering provides the cup depth and arm geometry that a standard hinge cannot offer on a thicker door panel.
• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• 1/2 inch overlay, half crank arm positions the door at a partial overlay, including two doors sharing a center partition.
• Screw-on mounting fastens directly to the cabinet with wood screws for a solid, fixed connection.
• Works on face-frame and frameless cabinets when paired with the appropriate Salice base plate, sold separately.

Where the Wide Swing and Thick Door Come Together

A standard concealed hinge is engineered for doors in the 16 to 22mm range and opens to 110 degrees in everyday use. When the door is thicker than that window or the application calls for a much wider swing, you need different geometry, and that is exactly what this hinge delivers. The 155 degree opening angle lets the door swing almost parallel to the cabinet side, which is valuable at corners, on appliance garages, and anywhere the contents of a deep cabinet need to be fully accessible. The thick-door cup seating and arm dimensions handle the added door mass without the cup perforating the face or the arm binding on closure. The 35mm cup bores into the door and the arm connects to a Salice base plate mounted to the cabinet, ordered separately. Plate selection should match your cabinet construction, face-frame or frameless, and the desired overlay position.

Steel Build in a Nickel Finish

The hinge is plated steel finished in nickel. Screw-on mounting means the arm fastens to the plate with screws rather than a tool-free clip, which gives a fixed connection suited to the added door weight a thick-door hinge is designed to carry. Post-install adjustment is available: height adjusts plus or minus 2mm and side adjusts plus 4.5mm or minus 1.5mm, letting you dial in an even reveal across a run of doors after the cabinet is set.

Right Application, Right Hinge

Reach for this hinge when the build specifies a thick door and the design calls for maximum swing clearance, such as a corner cabinet where a door that opens to only 110 degrees would block access to half the interior. The 1/2 inch overlay and half crank also make it the right pick for pairs of doors meeting on a shared center partition, where full-overlay geometry would put two arms in collision. Cabinet shops building thick-door frameless boxes and face-frame contractors working with heavier raised-panel doors are the natural fit. Because this is a self-close hinge, the spring closes the door on its own, but there is no damper cushioning the final contact. If the project calls for a quiet, slam-free close on a thick door, look to the Silentia+ soft-close version in this series instead.

Common Questions

Maximum Access on Doors Built to Take More

When a thick door needs to open wide and close on its own, this hinge is the specific tool for that job, on either cabinet type, at a working overlay that handles shared partitions too.