Nickel Concealed Hinge for Wide-Swing 1/2 Inch Overlay Doors

This Salice Series 200 concealed hinge opens to 155 degrees and is built for 1/2 inch overlay doors on both face-frame and frameless cabinets, including paired doors that share a center partition.

Key Features

• 155 degree opening angle swings the door almost flat, giving exceptional access to cabinet contents.
• Self-close spring draws the door shut over the last few degrees of travel so it latches without a push.
• 1/2 inch overlay, half crank arm positions the door at a partial overlay, the geometry for paired doors on a shared partition.
• Screw-on mounting fastens directly to the cabinet side or face-frame stile with wood screws for a solid, no-movement connection.
• Nickel finish on a steel body for a clean, professional look inside the cabinet.
• Height and side adjustment dials in door alignment after the hinge is mounted.

Where the 155 Degree Opening Earns Its Keep

A 155 degree swing lets a door fold back to nearly flat against the adjacent cabinet or wall, which matters most in corner cabinets, appliance garages, and anywhere a standard 110 degree door would block a workspace. The half crank arm handles the 1/2 inch overlay geometry, so two doors can meet on a single center partition without the arms colliding. The 35mm cup bores into the back of the door in the standard position, and the hinge body screws to a matching Salice base plate on the cabinet, ordered separately. That plate is brand-specific, so pair it with Salice's own plate range.

Steel Build in a Nickel Finish

The hinge body is steel with a nickel finish. Screw-on mounting means the hinge locks to the cabinet mechanically rather than relying on a clip or press-fit, which suits production environments and replacement work where a firmly anchored connection matters. The built-in height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm to minus 1.5mm give enough range to bring doors to an even reveal after installation without shimming.

The Right Fit for This Job

This hinge belongs on face-frame and frameless cabinets where a partial-overlay door needs a wide opening and a self-close spring pull. It suits kitchen renovations with corner runs, built-ins where doors open against a wall, and production cabinet shops sourcing a wide-angle hinge for standard 16 to 22mm doors. Note that the self-close spring draws the door shut but does not cushion the close. For a damped, quiet settle at the end of the swing, the Silentia+ soft-close version of the Series 200 is the right call instead.

Common Questions

Wide Access, Solid Close, Clean Look

Specify this hinge when the door needs to swing well out of the way, the overlay is a 1/2 inch partial, and a firm self-close spring is the right close for the job.