Nickel Concealed Hinge for Wide-Swing 1/2 Inch Overlay Doors

This Salice Series 200 hinge opens doors to 155 degrees with integrated Silentia soft-close, built for 1/2 inch overlay doors on face-frame and frameless cabinets, and mounted through pre-set dowels for a screw-free cup install.

Key Features

• 155 degree opening clears the cabinet interior fully, keeping everything inside reachable without bending around a partly open door.
• Silentia soft-close damps the door through the final closing arc so it settles quietly every time.
• 1/2 inch overlay, half crank arm positions the door over a shared partition or partial overlay opening.
• Dowel mounting presses the cup into pre-bored dowel holes with no cup screws, suited to CNC and production workflows.
• Face-frame and frameless compatibility lets this hinge work across both cabinet construction types when matched with the appropriate Salice base plate.
• Three-way adjustment dials in height, side, and position after the door is hung.

A 155 Degree Swing for Demanding Access

Most concealed hinges open to 110 degrees. This one goes to 155, and that difference matters in places where access matters: pantry cabinets, tall utility runs, appliance garages, and media cabinetry where a door that only half-opens is in the way. At 155 degrees the door swings back far enough to clear the cabinet face entirely, putting the interior fully in reach. The half crank arm sets the door to a 1/2 inch overlay, the geometry used when two doors share a center partition or when the design specifies partial overlay. The 35mm cup bores into the back of the door, and the dowel mount presses into the door's pre-bored dowel holes without cup screws, which is the method CNC shops and production lines run for consistent, fast installs. A Salice base plate mounts on the cabinet side and the arm attaches to it. That plate is sold separately and must be from the Salice line to match this hinge's arm engagement.

Steel Construction with a Nickel Finish

The hinge body is steel with a nickel finish. Silentia is Salice's integrated soft-close system, built into the hinge rather than added on, so there is no separate damper to source or clip on. It works through the full 155 degree range, cushioning the door as it closes. The nickel finish coordinates with brushed and satin hardware on the same cabinet run, and the steel construction holds adjustment over time. Height and side adjustment are available after install to bring doors to an even reveal as the cabinets settle.

Where This Hinge Earns Its Place

This is the right call for tall pantry doors, pull-out appliance bays, and any run where doors opening only partway create a practical problem. It suits cabinet shops that bore doors on CNC equipment and want a press-in cup install rather than screwed cups, and it works on frameless box construction and face-frame cabinetry alike. For a project specifying 110 degree standard swing, an overlay hinge in the same Series 200 family is the more economical path. For a door thicker than 22mm, move to a thick-door hinge. This hinge is for standard doors in the 16 to 22mm range where a wide swing and a quiet close are both on the requirement list.

Common Questions

Full Access, Quiet Close, Clean Nickel Finish

Specify this hinge where a 155 degree swing, press-in cup install, and integrated soft-close need to work together on a 1/2 inch overlay door.