Salice Angled Concealed Hinge for +45 Degree Bay and Diagonal Cabinets

This Salice Series 700 hinge is built for cabinet faces set at a positive 45 degree angle, the geometry found in bay cabinets, angled corner units, and diagonal appliance-garage frames, on both face-frame and frameless boxes. Silentia soft-close is integrated, and the cup mounts via pre-attached dowels for a clean, screw-free door installation.

Key Features

• +45 degree cabinet angle matches the outward diagonal face of bay and angled cabinet configurations.
• Silentia soft-close dampens the door over the final closing arc, preventing slam on an angled front.
• Dowel mount cup presses the hinge into pre-bored dowel holes in the door with no cup screws required.
• 110 degree opening angle delivers standard everyday access on a diagonally set door.
• Works on face-frame and frameless cabinets when paired with the appropriate Salice base plate, sold separately.
• Three-way adjustment brings the door to an even reveal after hanging, with height and side correction built in.

The Right Hinge for a Diagonally Faced Cabinet

A standard concealed hinge cannot handle a cabinet face that angles outward. This hinge is engineered specifically for a +45 degree cabinet angle, so the door swings correctly without binding against the adjacent face or the cabinet side. It is the hinge to reach for when the design calls for a bay corner unit, an angled appliance garage, or a diagonal accent panel in a kitchen run.

The 35mm cup bores into the back of the door and the dowel mount presses into the pre-bored dowel holes, so there are no cup screws to drive. The arm then connects to a Salice base plate fastened to the cabinet. That plate is a separate purchase and must be a Salice plate matched to your cabinet construction, as Salice plates are not interchangeable with plates from other brands.

Series 700 Build and Silentia Damping

This hinge comes from Salice's Series 700, the premium tier in the Salice concealed line. The steel body carries a nickel finish, and the Silentia soft-close mechanism is built directly into the hinge rather than added on. On an angled cabinet face, where door mass and swing geometry differ from a flat front, that integrated damping keeps the close controlled and consistent. The cup seats 13.5mm deep, matching standard door thickness in the 16 to 22mm range.

Who Specifies This Hinge

Cabinet shops building bay or diagonal corner units are the primary audience here. It also suits designers specifying a kitchen with angled accent sections and contractors retrofitting hardware on an existing angled cabinet where the cup bore and dowel pattern are already in place. Because the dowel mount locks into pre-bored holes, it fits well in CNC-driven production environments where screw-free cup attachment is part of the process flow.

This hinge is for indoor cabinetry on standard-thickness doors. For doors outside the 16 to 22mm range, a thick-door or thin-door variant is the correct selection.

Common Questions

Angled Doors That Close Quietly and Hang True

Specify this hinge when the cabinet face breaks at 45 degrees and the finish has to match: a nickel concealed hinge with soft-close damping, built for the geometry that standard hinges cannot serve.