TopLine Grant Double Profile Track, 7004 with Fascia 4'

TopLine Grant Double Profile Track For Sliding Doors

TopLine Grant double profile track is a sliding door hardware component that guides by-passing doors so they travel on a defined path. This gives installers a dedicated track solution when planning sliding openings where doors overlap instead of swinging on hinges. The track is part of the builders hardware and sliding door hardware category, so it fits naturally into door layouts where a straight, repeatable slide is required. Hettich America Corporation manufactures this track, giving shops and field crews a consistent source when they need matching components across multiple openings. The 4 foot length supports layouts where the opening or door width aligns with that span, which helps with straightforward measuring and cutting on site. The fascia on the track provides a built-in way to cover the working profile, which can support cleaner visual lines across the front of the opening.

Key Track Details That Support Door Projects

• The double profile design creates two running paths for by-passing doors, which lets one door slide in front of the other and helps conserve swing space in tight layouts.
• The double I-beam track shape gives each profile defined running flanges, supporting smooth door travel along a consistent line during repeated opening and closing.
• The integrated fascia runs along the track, covering the structural profile so visible hardware is reduced and door openings present a more finished appearance.
• The 4 foot track length ties directly to common opening sizes, which simplifies layout, cutting, and alignment during cabinet, closet, or similar sliding-door installations.
• The Hettich America Corporation brand connection matches this track to the broader TopLine Grant sliding door hardware range, helping maintain part consistency across multiple door runs.

Sliding Track Layout, Fascia Orientation, And Fit

The double I-beam track with fascia sets up two distinct running profiles, so installers can locate by-passing doors on separate paths while keeping them aligned along the opening. This arrangement supports layouts where one door needs to clear another without swing clearance, which is common in tight corridor or cabinet conditions. The fascia sits along the track and covers the exposed track body, so the visible line above the doors is more uniform once the system is mounted. The 4 foot length works as a planning dimension when setting header or top panel locations, because the track and fascia span match that size. As a result, both shop-built and on-site builds can frame openings around the track length for predictable fit.

Using This Track In Real Sliding Door Builds

Where This Double Profile Track Is Applied

This TopLine Grant double profile track is intended for use wherever by-passing doors are needed, because the dual profiles give each door its own travel lane. Installers can place one door on the front profile and another on the rear profile, so the leaves pass each other instead of colliding at mid-span. That makes the track especially useful in sliding door hardware layouts where floor space is limited, such as built-in cabinets or storage runs. Being classified under builders hardware and sliding door hardware, the track fits into woodworking projects that already use similar components from Hettich America Corporation. The 4 foot span aligns with many cabinet and small opening widths, which supports designs that use a single track length over the full clear width.

Why Track Design Details Matter For Results

The double I-beam track form provides two structural webs and flanges, which define consistent running edges for the by-passing doors. This geometry helps the door carriers or hangers follow the same route each cycle, which supports predictable door alignment over time. When the fascia is part of the track, installers do not need a separate trim piece to conceal the track body, which can reduce steps during finish-out and keep the header line visually consistent. The 4 foot factory length gives crews a fixed reference when cutting surrounding materials, so they can size valances, headers, or top panels around a known track dimension. Working with a product identified by manufacturer part number 50547 allows shops to specify or reorder the exact same TopLine Grant double profile track across several projects, keeping motion characteristics and fascia appearance uniform from opening to opening.

Common Questions About This Sliding Door Track

Selecting This Track For By-Passing Door Runs

Choose the TopLine Grant double profile track when a 4 foot sliding span and by-passing door layout match the opening you are building. The double I-beam track with fascia establishes two guided profiles and a clean front edge, giving woodworking and construction teams a defined sliding door hardware component for these applications.