Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #8 x 1/2" truss head hinge and drawer slide installation screw is built for mounting European-style hinges, drawer slides, and cabinet hardware to panel stock where a short fastener is required. The 1/2" length is sized for hardware mounting plates with limited panel depth, keeping the screw well clear of the face surface without sacrificing grip in the substrate.
A 1/2" screw is the right call when a hardware mounting plate sits against a panel and the available panel depth is limited. European cup hinges, undermount drawer slides, and side-mount slide hardware are often designed for exactly this screw length, where a longer fastener would either bottom out in thin panel stock or push through into a visible interior surface. The truss head's broad bearing flange distributes clamping load across the mounting plate hole without digging in, which keeps hardware seated squarely and reduces the chance of the plate rocking under door or drawer cycling.
These are steel screws with a zinc finish suited to dry indoor cabinetry. The fine thread engages well in plywood, hardwood, and composite panel material commonly found in cabinet carcasses and face frames. The #8 gauge matches the pre-drilled hole diameter on most European hinge mounting plates and standard drawer slide brackets, so the head seats properly without enlarging the mounting hole or stripping the plate. For wet or high-humidity environments, a screw with additional corrosion protection is the better choice.
Cabinet shops running production lines reach for this screw to keep hinge and slide installation moving without stopping to sort lengths. Installers specifying hardware mounting on frameless or face-frame cabinets with thinner panels also rely on the 1/2" length to avoid breakthrough on finished interior surfaces. Having 1,000 on hand means a box lasts through a full run of cabinets or a multi-cabinet site install before a reorder is needed.
The truss head's wide, flat bearing surface spans the mounting hole on a hinge plate or drawer slide bracket and distributes clamping load evenly. This prevents the head from pulling through thin mounting hardware and helps keep the plate seated flat against the panel.
Yes. Fine thread performs well in plywood, hardwood, and dense composite panels. It provides more thread engagement per inch than coarse thread, which supports reliable holding power in the panel materials typical of cabinet carcass construction.
In most hardware mounting applications, the hinge plate or slide bracket already has pre-drilled holes that guide the screw. The sharp point self-starts in those holes. For installations directly into solid hardwood without a mounting plate, a pilot hole will reduce splitting and driving resistance.
Zinc finish is well suited to dry indoor environments, including standard kitchen and bath cabinet interiors above the countertop line. For areas with sustained moisture exposure, a screw with a heavier corrosion-resistant coating is the better fit.
Each box contains 1,000 screws, which supports extended production runs or full-project installs without frequent reorders.
When panel depth is tight and hardware plates need a clean, flush mount, the 1/2" length in this truss head screw gives installers and cabinet makers a reliable fastener that fits the application without modification or compromise.
Sold In: 1000 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 10 Each |  WW614176461 Mfr# 0614176461005 10 | #2 x 1" Phillips Drive Insert Bit (10/Bag) |