
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
This Würth #6 x 5/8" flat head screw is built for mounting European cup hinges, drawer slides, and cabinet hardware to panels where a standard-length screw would over-penetrate or break through the back face. At 5/8" long, it seats fully in thin stock without compromising the panel behind it.
Most hinge and drawer slide screws seat into cabinet side panels, face frames, or door stiles that run 1/2" to 3/4" thick. A longer screw in those locations risks punching through the visible face or leaving a dimple in a finished surface. The 5/8" length gives full thread engagement in the panel while stopping short of the opposite face. It also fits the shallow-depth mounting conditions common in frameless cabinet construction, where hardware plates sit directly on 5/8" or thinner melamine-faced panels. For hinge cups bored into overlay doors or mounting clips fastened to the cabinet interior, this screw provides the holding power the joint needs at exactly the depth the material allows.
The nickel finish coordinates with the chrome and brushed-silver tones of most European hinge hardware and steel drawer slides. In finished cabinet interiors where hardware is visible, a matched finish reduces visual clutter. The flat head profile is sized to seat inside the countersunk mounting holes of standard hinge plates and slide brackets, sitting flush rather than proud. Coarse thread construction bites quickly into particleboard, MDF, and plywood without requiring a pilot hole in most installations, and the sharp point self-starts cleanly.
A single kitchen or bath cabinet run can consume hundreds of hinge and slide screws before the first door is hung. At 30,000 per box, this SKU is sized for shops that run continuous production and cannot afford to pause for a resupply mid-job. The #2 Phillips drive is universal across pneumatic and corded installation tools, so there is no bit changeover when the crew moves from hinges to slides to hardware mounting. Installers setting cabinets on site will find the same screw handles clip-on hinge plates, undermount slide mounting clips, and face-frame hardware attachment in a single pass through the tool belt.
When the panel or door stile is 1/2" to 5/8" thick, a 3/4" screw can break through or dimple the opposite face. The 5/8" length gives full thread engagement without that risk.
Yes. The #6 gauge flat head is sized to seat in the countersunk holes of standard cup hinge mounting plates and most clip-on hinge bases used in 32mm system cabinetry.
The sharp point and coarse thread self-start in particleboard and MDF without a pilot hole in most cases. Pre-drilling near edges or in very dense material reduces splitting risk.
Nickel and chrome are close in tone and work well together visually in finished cabinet interiors. Neither finish is intended for exterior or high-moisture applications.
Yes. The flat head and #6 gauge fit the mounting holes on most side-mount and undermount drawer slide brackets. Confirm that 5/8" provides adequate penetration depth for the panel thickness in your application.
The 5/8" Würth hinge and drawer slide screw is the right call when the panel is thin, the clearance is tight, and the job count is high. It gives cabinet shops and installers a screw that fits the hardware, suits the material, and keeps production moving.
Sold In: 30000 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 10 Each | WW614176461 Mfr# 0614176461005 10 | #2 x 1" Phillips Drive Insert Bit (10/Bag) |