Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #6 x 5/8" flat head hinge and drawer slide installation screw is built for mounting cabinet hinges, drawer slides, and similar hardware to cabinet panels where a short, clean-seating fastener is needed. The Nickel finish blends with silver-toned hardware, and the Phillips drive works with the bits already on hand in any shop.
The 5/8" length is the practical choice when hardware mounts directly to a 3/4" cabinet side, face frame, or thin overlay panel. At this length, the screw engages enough material to hold hinge plates and drawer slide brackets firmly while stopping well short of breaking through the panel face. It is the standard length for compact European cup hinges and most side-mount drawer slide mounting clips, where the pre-bored mounting holes are sized for a #6 shank and the installation depth is intentionally shallow.
The Nickel finish gives the installed screw head a clean, silver tone that sits naturally alongside brushed nickel, satin nickel, and polished chrome hardware. In kitchen and bath cabinet work, exposed screw heads inside the cabinet box are often visible, and a finish-matched fastener is a detail that distinguishes a careful install. The 5000-piece box supports high-volume use across a full project or production run without the interruption of mid-job restocking.
Cabinet shops running European frameless or face-frame construction both reach for a screw like this when hanging hinges and mounting drawer slides. The short length and flat head suit any application where the hardware manufacturer specifies a #6 screw and the panel depth limits how far the fastener can go. Installers trimming out kitchen or bath cabinetry on site use the same screw to remount hardware after finish adjustments. The Phillips drive is a universal fit for the tools already in a van or shop drawer, so there is no bit change required when moving between tasks.
Most European hinge plates and drawer slide mounting clips are designed for a #6 screw at 5/8" length. That depth seats the fastener fully through the hardware plate and into the cabinet panel without risking breakthrough on a 3/4" side wall, especially near routed or dadoed areas where panel thickness may be reduced.
In most installations the screw head sits recessed under the hardware plate or within the mounting clip, so the finish is not visible. Where the head is exposed inside the cabinet, the Nickel tone matches standard silver-finished hardware rather than contrasting with it.
Yes. The coarse thread is suited for the fiber structure of both plywood and particleboard, which are the two most common cabinet carcass materials. It also performs well in MDF.
A standard #2 Phillips bit drives this screw. No specialty bit is needed.
A full kitchen install can consume several hundred hinge and slide screws across all the hardware points. For an installer doing multiple projects or a shop in production, a 5000-piece box is a working supply, not excess inventory.
When the hardware fits, the finish matches, and the screw length is right for the panel, hardware installation moves quickly and the finished cabinet looks the part.
Sold In: 5000 Each
