
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
This Würth #6 x 5/8-inch flat head screw is built for mounting European cup hinges, drawer slides, and other cabinet hardware to 3/4-inch panels where a short, flush-seating fastener is the right tool. The Phillips drive and zinc finish make it a straightforward fit for production shops running high daily install counts.
Short hardware-installation screws get overlooked until a longer substitute blows through the back of a panel or strips a mounting hole. At 5/8 inch, this screw is proportioned for the shallow installation depth that European hinge plates and drawer slide mounting brackets actually require. The screw seats the hardware plate firmly against the panel face without the tip approaching the finished side of 3/4-inch stock. That matters in face-frame and frameless cabinet construction alike, where exposed interiors need a clean face and hardware that sits tight from day one.
The zinc plating on this screw handles the dry, climate-controlled conditions of residential and commercial cabinet interiors without issue. It is not rated for exterior or high-moisture environments, but for standard cabinet installation inside a kitchen, bath, laundry, or built-in, it delivers the corrosion protection the application calls for. The flat head geometry lets the screw pull flush against hardware plate surfaces so hinge arms and slide brackets sit evenly and move without drag from a proud fastener head.
Cabinet shops driving dozens of hinges and slides per case run through installation screws faster than most fasteners in the shop. A 30,000-count box keeps production moving without constant restocking interruptions. The #2 Phillips drive is compatible with the bit already on most production drivers, so there is no workflow change required. This screw fits frameless cabinet hardware installations as naturally as it fits face-frame work, and it covers European-style hinge plates as well as side-mount and undermount drawer slide hardware where the mounting plate calls for a short, flat-head screw.
Hardware mounting plates are drilled for a specific fastener depth. A screw that is too long risks breaking through the back face of the panel or splitting the substrate near the edge. The 5/8-inch length is matched to the shallow embedment depth that most European hinge plates and drawer slide brackets require in 3/4-inch cabinet panels.
Yes. The flat head, coarse thread, and sharp point suit hardware mounting on both frameless (32mm system) and face-frame cabinet panels made from plywood, particleboard, or MDF.
The sharp point self-starts through hardware mounting holes into panel faces without a separate pilot hole in most cabinet panel materials.
A #2 Phillips bit. That is the standard bit size for this gauge and is already loaded on most cabinet installation drivers.
No. The zinc finish is suited for dry interior environments. For outdoor or high-moisture applications, a screw with a heavier corrosion-resistant coating is the better choice.
Hinge and slide installations account for a large share of screws driven in any cabinet shop. Having the right length on hand, in a quantity that keeps pace with production, removes one more variable from a busy install day.
Sold In: 30000 Each