Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #6 x 5/8" flat head hinge and drawer slide installation screw is sized for mounting European cup hinges, drawer slides, and similar cabinet hardware to standard 3/4-inch panels without over-penetrating the substrate. A #2 Phillips drive, coarse thread, and zinc finish make it a straightforward production choice for frameless and face-frame cabinetry alike.
Most hinge and drawer slide mounting plates are pre-drilled for screws in the 5/8-inch to 3/4-inch range. The 5/8-inch length threads fully into the panel while keeping the tip well short of the opposite face on 3/4-inch sheet goods. That matters most when the panel back is a finished surface, a laminated interior, or a visible side that cannot be patched. Installers working on cabinet sides, partitions, and drawer-box panels where both faces are exposed will find this length consistently safe across standard panel thicknesses.
The #2 Phillips drive is the default for cabinet installation work, and this screw is designed around that reality. The coarse thread engages quickly in the fiber structure of plywood, particleboard, and MDF, the three materials most common in cabinet carcass construction. A sharp point self-starts without a pilot hole in these substrates, keeping the installation pace up when running dozens of hinges or slides in a single session. The zinc finish suits the dry, climate-controlled conditions of finished cabinet interiors and provides the baseline corrosion resistance appropriate for indoor hardware applications.
Cabinet shops installing European-style concealed hinges, undermount slides, or side-mount drawer slides go through hinge screws at a rate that makes pack size a practical consideration. A 5,000-piece box supports extended production without restocking interruptions. The #6 gauge matches the pre-drilled pilot holes in standard hinge and slide mounting plates, so the head seats correctly against the plate face without rocking or standing proud. This screw works equally well for installers fitting hardware on a finished job site or for shops running a full batch of cabinet boxes on the assembly floor.
Yes. Most European hinge mounting plates are designed for screws in the 5/8-inch to 3/4-inch range, and the 5/8-inch length threads fully into 3/4-inch panels without reaching the opposite face.
The sharp point self-starts in particleboard, MDF, and plywood without a pilot hole. For installations very close to a panel edge, a pilot hole reduces the risk of the material crumbling at the edge.
Yes. The #6 gauge is the standard size for European hinge and drawer slide mounting plates. The head seats flush against the plate without oversizing the hole or leaving a gap under the head.
The zinc finish is suited for dry indoor conditions. For installations in humid environments such as outdoor kitchens or laundry rooms, a screw with a heavier corrosion-resistant coating is a better choice.
A standard #2 Phillips bit. No specialty bit is required.
When the hardware count runs into the hundreds across a kitchen or commercial casework project, the screw that mounts it all should be one less thing to think about. The Würth #6 x 5/8" hinge and drawer slide installation screw is sized, threaded, and packed to keep installation moving from the first cabinet to the last.
Sold In: 5000 Each
