Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #5 x 1/2-inch flat head screw is built for mounting European cup hinges, drawer slides, and similar cabinet hardware to panel stock without over-penetrating thin material. The short 1/2-inch length makes it the right reach for hardware mounting plates seated in 3/4-inch panels where a longer screw would break through the back face.
European cup hinges and side-mount drawer slides attach through pre-punched holes in their mounting plates directly into the cabinet panel face. The 1/2-inch screw length is sized to engage the panel securely without the tip exiting through the opposite face on standard 3/4-inch material. That matters in frameless cabinet construction where the interior face of the panel is visible and a protruding tip would create a snag point or cosmetic defect. The flat head sits tight against the mounting plate surface, keeping the hardware positioned correctly and allowing adjustments without the fastener head interfering with the plate geometry.
The screw is steel with a zinc electroplate finish. Zinc provides galvanic protection against rust in the dry, climate-controlled conditions typical of kitchen, bath, and furniture cabinet interiors. The coarse thread profile is calibrated for the fiber matrix of engineered wood panels — particleboard, MDF, and plywood — where the wider thread pitch maximizes pull-out resistance in the softer substrate. No nibs are present on the underside of the head, which keeps the flat head profile low and consistent as it seats against machined hardware plates.
Cabinet shops running production lines benefit from a dedicated hardware installation screw that eliminates the guesswork of selecting a substitute from a general-purpose bin. Using a screw sized specifically to the hardware keeps installation consistent across every cabinet in a run. Installers working on site — fitting hinges or re-hanging slides during a renovation — get the same advantage: one screw that works for both hinge plates and slide mounting brackets without swapping fasteners mid-job. The 1,000-piece box suits both settings, providing enough volume for a production batch or a stockpile that carries through several jobs.
Yes. The #5 gauge and flat head profile match the pre-punched holes in most European hinge mounting plates and side-mount drawer slide brackets. Verify the hole diameter of your specific hardware before installing.
At 1/2 inch, the screw engages the panel face firmly without the tip breaking through the back of standard 3/4-inch cabinet stock. That keeps the interior face clean and prevents snag points in frameless cabinet interiors.
Yes. The coarse thread is suited to the fiber matrix of engineered wood panels including particleboard, MDF, and plywood, where it provides reliable pull-out resistance.
The zinc finish is designed for dry indoor environments. It is not suited for exterior exposure or high-humidity settings such as unventilated crawl spaces or outdoor furniture.
A standard #2 Phillips bit drives this screw. No specialty bit is needed.
Keep this 1/2-inch Würth hinge and drawer slide screw on hand and hardware installation stays straightforward — the right gauge, the right length for 3/4-inch panels, and a drive that works with the bit already in the drill.
Sold In: 1000 Each
