
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Würth #5 x 1/2" flat head hinge and drawer slide installation screw is built for mounting European cup hinges, drawer slides, and similar cabinet hardware to panel interiors. The Phillips drive pairs with a flat countersunk head sized to seat cleanly in the pre-formed countersinks of standard hinge plates and slide brackets, keeping fastener heads flush and hardware secure.
Hinge and drawer slide installation is detail work. The screws are short, the mounting holes are pre-sized, and the hardware sits precisely where the head seats. A flat countersunk head is the right profile here: it follows the countersink geometry already formed into the hinge plate or slide bracket and pulls the hardware tight against the cabinet panel without any protrusion above the mounting surface. That matters in the cabinet interior, where a proud fastener head can interfere with drawer box clearance or door swing.
The 1/2" length is matched to this application. It delivers enough thread engagement into 3/4" cabinet panel stock without breaking through the back face, and it works in both frameless cabinet sides and face-frame panel edges where the mounting hole lands close to the surface.
Fine thread provides the close thread pitch that grips well in hardwood and hardwood-veneered plywood, the materials most commonly found in quality cabinet carcasses. The #5 gauge matches the hole diameter specified for most European hinge mounting plates and standard drawer slide brackets, so the shank fits properly and the head seats in the countersink without rocking or standing proud. Zinc plating provides indoor corrosion protection suitable for the dry environment inside a cabinet.
Phillips drive is the default bit in most shops and on most install trucks. Using a #2 Phillips screw for hinge and slide work means no bit swap when moving between hardware installation and other cabinet tasks. For installers hanging a full kitchen's worth of hinges and drawer slides in a single session, staying on one bit keeps momentum on the job. The box of 1,000 supports that volume without mid-job restocking.
Yes. The flat countersunk head is sized to seat flush in the pre-formed countersinks on standard European hinge mounting plates and drawer slide brackets, pulling the hardware tight against the cabinet panel surface.
It takes a #2 Phillips driver bit, the most common size in shop and jobsite kits.
Fine thread provides tighter thread spacing and better grip in hardwood and hardwood-veneered plywood, which are the primary materials in quality cabinet construction.
Yes. The 1/2" length provides enough thread engagement to hold hardware securely in 3/4" panels without the risk of the point breaking through the back face of the panel.
Yes. The #5 gauge, flat head, and 1/2" length suit both European cup hinge mounting plates and standard drawer slide brackets that share the same mounting hole specification.
When the hinge plates and slide brackets are positioned and the bit is loaded, this screw's flat head, fine thread, and 1/2" length do exactly what hardware installation demands: seat flush, grip the panel, and hold the hardware in place through years of door cycles and drawer pulls.
Sold In: 1000 Each