This Würth #6 x 5/8-inch flat head screw is built for mounting European cup hinges, drawer slides, and other cabinet hardware to 3/4-inch panel stock without punching through the back face. The short 5/8-inch length hits the sweet spot for hardware mounting plates and slide brackets that sit directly on the interior panel surface.
Mounting European cup hinges and drawer slides calls for a screw that is short enough to stay well clear of the panel face opposite the hardware, yet long enough to grip reliably in engineered sheet goods. At 5/8 inch, this screw threads into the mounting plates of standard concealed hinges and side-mount drawer slides without breaking through 3/4-inch plywood or particleboard sides. It also handles face-frame hardware brackets and hinge base plates on melamine cabinet interiors, where a longer screw would telegraph through or compromise the surface.
The screw is zinc-plated carbon steel, which provides reliable protection against oxidation in the controlled, dry environment inside a finished cabinet. The flat head countersinks into the pre-formed seat of most hardware mounting plates, and the coarse thread starts fast in the low-density fiber matrix of particleboard and MDF. The #2 Phillips drive is the standard on most production screw guns and cordless drivers, so no bit swaps are needed during a hardware installation run.
At 30,000 screws per box, this SKU is sized for cabinet shops and millwork operations that install dozens of hinges and drawer slides every shift. A single box supports hundreds of cabinets without the disruption of restocking mid-run. Contractors and installers fitting out larger residential or commercial projects will also find the bulk quantity practical for a full job site supply. For shops building face-frame or frameless cabinets in plywood, particleboard, or MDF, the #6 gauge and 5/8-inch length cover the majority of standard hardware plate sizes on the market.
A screw that is too long can punch through a thin panel or a finished interior surface. At 5/8 inch, this screw provides solid thread engagement in 3/4-inch panel stock while leaving a comfortable margin before the tip reaches the opposite face.
Yes. The #6 gauge shank is the standard size for the pre-drilled holes in European cup hinge base plates and most drawer slide mounting brackets. It seats without enlarging the hole or requiring a pilot.
Yes. The coarse thread grips efficiently in particleboard and MDF, which are the most common substrates in flat-pack and production cabinet construction. It works equally well in plywood cabinet panels.
Yes. The flat head profile seats into the countersunk opening of standard hinge and drawer slide mounting plates, sitting flush with or below the plate surface so hardware aligns correctly against the cabinet panel.
Yes. The zinc finish is rated for dry indoor environments. It is the right choice for finished cabinet interiors and is not intended for exterior or high-humidity applications.
When the hinge count is high and the schedule is tight, having the right short screw in the right quantity means hardware installation stays on pace from the first cabinet to the last.
Sold In: 30000 Each
