Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #5 x 1/2" flat head screw is built for mounting European cup hinges, drawer slides, and other hardware plates to cabinet panels where a short, precise fastener is the right fit. The compact 1/2" length keeps the screw within the panel without risking blowout through thin stock, and the #5 gauge matches the mounting holes in most standard hardware plates.
Hinge and drawer slide plates arrive from the factory with pre-bored countersunk holes sized for a #5 or #6 screw. A standard-length screw in those holes risks punching through the back of a 1/2" or 3/4" panel if depth is not carefully managed. This 1/2" screw eliminates that concern: it seats the hardware plate firmly without approaching the panel's opposite face. That makes it practical for frameless cabinet boxes with thin sides, plywood cabinet interiors, and any installation where panel integrity matters.
Drawer slide mounting clips and hinge base plates both call for a screw that pulls the hardware flat against the panel without stripping the hole or lifting the plate. The fine thread on this screw develops consistent holding power in the panel material, and the flat head drops into the countersink in the hardware plate to sit flush rather than proud.
The bright zinc finish provides standard corrosion protection appropriate for indoor cabinetry. These screws are at home inside a kitchen cabinet box, a bathroom vanity, or a built-in where the hardware will never see moisture or outdoor exposure. The zinc coating also keeps the screw head looking clean against the interior surface of a finished cabinet panel.
Cabinet shops running production lines and installers doing service work both need a reliable short screw for hardware mounting that does not require hunting through bins for the right gauge. This screw covers hinge plate attachment, drawer slide clip mounting, and similar hardware-fastening tasks where a #5 x 1/2" flat head is the specified fit. The 100-piece box is a sensible quantity for a shop drawer or service bag, providing enough screws to complete several cabinet installations or handle a full kitchen service call without running short.
Yes. European cup hinge mounting plates use pre-bored countersunk holes that accept a #5 or #6 flat head screw. The 1/2" length keeps the screw within the cabinet panel, and the flat head seats flush in the countersink of the mounting plate.
Hardware mounting plates sit directly on the panel face, so the screw only needs to penetrate the plate thickness plus enough panel depth to grip securely. A 1/2" screw provides that grip without risking blowout through thinner panels or penetrating deeply into the finished interior of the cabinet.
Yes. Drawer slide mounting clips and side-mount slide brackets commonly use a short flat head screw in the #5 or #6 gauge range. This screw fits those pre-bored holes and pulls the hardware flat against the panel.
The sharp point self-starts in most cabinet panel substrates. When installing into pre-bored hardware mounting holes, the hole in the plate guides the screw into the panel, so no separate pilot is needed in typical cabinet installation.
Yes. The zinc finish is suited for dry indoor cabinet environments. It is not rated for exterior, high-humidity, or treated-lumber applications.
When hardware plate holes call for a short, flat head fastener that seats flush and stays within the panel, this Würth #5 x 1/2" screw delivers a clean, secure mount without overcomplicating a routine part of every cabinet installation.
Sold In: 100 Each
