Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #5 x 5/8 inch flat head screw is purpose-built for mounting European cup hinges, drawer slides, and other cabinet hardware to panel interiors. The 5/8 inch length is sized to seat hardware firmly in 3/4 inch cabinet panels without penetrating the opposite face, making it the right fit for standard frameless and face-frame cabinet construction.
Hinge mounting plates and drawer slide brackets come with pre-drilled holes sized for a specific screw gauge and head profile. At 5/8 inch, this screw engages enough material to hold hardware securely under repeated door and drawer cycling while stopping well short of the panel's show face. That balance matters in production cabinet work, where a screw that bottoms out too soon or punches through the back of a panel creates rework. This length also suits hinge cup mounting plates in standard 3/4 inch cabinet sides and face frames, where hardware is installed directly into the panel without a through-bore.
The flat head profile is designed to sit flush within the countersunk holes of hinge and slide mounting hardware, keeping the bracket pulled tight against the panel face without any standoff. A #2 Phillips bit — the most common size in cabinet shops — drives these without a special bit purchase. The zinc finish is appropriate for the dry, enclosed environment inside a finished cabinet, where hardware is shielded from moisture. This is an indoor screw; choose a corrosion-rated fastener for any installation exposed to humidity or exterior conditions.
This screw fits naturally into the workflow of a cabinet shop running European hinges and side-mount or undermount drawer slides at volume. The coarse thread and sharp point allow rapid driving into plywood, particleboard, and MDF panel materials without pre-tapping. A box of 1000 supports a full day of hinge and slide installation without mid-run restocking. Finish carpenters and on-site cabinet installers will find the same advantages when hanging pre-assembled cabinet boxes and attaching hardware after delivery.
Most European hinge mounting plates and drawer slide brackets are designed for 3/4 inch panels. A 5/8 inch screw provides enough thread engagement to hold hardware securely while leaving a safe margin before the screw tip reaches the opposite face of the panel.
The coarse thread and sharp point are suited for plywood, MDF, particleboard, and melamine-faced engineered panels — the materials most commonly used for frameless and face-frame cabinet boxes.
Hardware mounting plates and slide brackets typically come with pre-bored holes that act as guides. The sharp point self-starts in those holes without additional drilling in most engineered panel materials.
No. The zinc finish is rated for dry, interior environments. For installations in areas with humidity exposure, choose a screw with a higher-rated corrosion-resistant finish.
A standard #2 Phillips bit. No specialty tooling is required.
With 1000 screws per box and a size matched to standard cabinet hardware mounting, this Würth hinge and drawer slide installation screw removes one variable from a high-repetition task — so hinges seat cleanly, slides mount square, and the job keeps moving.
Sold In: 1000 Each
