
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Würth #6 x 1-inch flat head hinge and drawer slide installation screw is sized for mounting European cup hinges and drawer slides to cabinet panels where the full 1-inch length provides solid thread engagement through typical 3/4-inch cabinet stock. The Nickel finish and flat head profile give it a clean, finished look inside cabinet interiors where fastener heads are visible.
At 1 inch, this screw is matched to the most common cabinet panel thickness in residential and commercial cabinetry. When a European cup hinge or drawer slide mounts to a 3/4-inch side panel, a 1-inch screw threads fully into the panel without breaking through the opposite face. That makes it the right call for frameless cabinet boxes, face-frame interiors, and any installation where penetration depth matters. It also works for attaching drawer slide brackets to cabinet sidewalls and for securing hinge base plates to face frames in standard 3/4-inch hardwood or plywood construction.
The Nickel finish holds up in cabinet interiors and pairs naturally with the brushed nickel and satin chrome hardware commonly specified in kitchens and baths. The flat head seats flush in the countersunk holes pre-drilled into hinge plates and slide mounting brackets, so the hardware sits tight against the panel face without any gap or rock. A #2 Phillips drive handles the installation with any standard driver bit, and the coarse thread bites quickly in wood-based panels including plywood, particleboard, and MDF. This screw does not carry nibs, so the mounting hole in the hardware plate does the countersinking work.
Cabinet shops running production installations keep a box of these on the drill station because the 1-inch length covers the most common mounting scenario without a second size on the bench. Installers fitting out a kitchen or bath will use them from the first hinge to the last drawer slide without a size change. Finish carpenters handling one-off cabinet installs find the 1000-piece count practical for a multi-cabinet job without carrying excess inventory. Anywhere European hinges and full-extension drawer slides go into standard 3/4-inch panels, this screw is the daily-use choice.
Yes. The 1-inch length threads fully into 3/4-inch plywood or particleboard panels through the pre-drilled holes in standard hinge mounting plates and drawer slide brackets without over-penetrating the panel face.
The Nickel finish coordinates well with brushed nickel and satin chrome hardware. For installations where fastener heads are visible inside the cabinet, the finish blends rather than contrasts with common hardware finishes.
No. This screw is designed for hardware that already has a countersunk hole in the mounting plate. The flat head seats directly into that pre-formed recess. Nibs are not required and are not present on this screw.
Yes. The coarse thread and sharp point are well suited to plywood, MDF, and particleboard, which are the most common substrates in frameless cabinet construction.
A standard kitchen with 20 to 30 cabinets, two hinges per door, and multiple drawer slides can consume several hundred installation screws. A 1000-piece box covers a full kitchen comfortably and leaves stock for the next job.
One consistent screw size for hinges and slides from the first cabinet to the last means no fumbling for a second box mid-install. The Würth #6 x 1-inch flat head installation screw in Nickel gives cabinet shops and installers a ready supply of the size that fits standard 3/4-inch panels all day long.
Sold In: 1000 Each