Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 20 inch side-mount ball bearing drawer slide from Fulterer, rated 198 lb per pair, with 1 inch of over-travel beyond full extension and an integrated soft-close damper. The zinc finish blends cleanly into cabinet interiors and holds up through years of daily use indoors.
Most 100 lb cabinet slides stop at the cabinet face when fully open. This slide goes an inch further, which matters when the drawer sits under a counter overhang, behind a thick face frame, or inside a deep pantry cabinet. That extra inch of travel pulls the rear contents clear of the frame edge so nothing stays buried in the back. Pair that with a 198 lb capacity and the slide suits drawers that would stress a standard kitchen slide: heavy-duty shop drawers carrying tools, deep pantry pull-outs loaded with canned goods, utility cabinets in a commercial workroom, or any application where the drawer regularly runs close to the 100 lb ceiling of the standard class.
Steel members with a zinc finish provide the indoor corrosion resistance this slide class is built on. Zinc is a functional, low-profile finish — it protects the steel through daily cycling without drawing attention beside an open drawer box. This is not a decorative or stainless finish; it is the working standard for side-mount ball bearing slides in indoor cabinetry, and it is appropriate for dry, interior environments. The 1/2 inch side clearance per side is consistent with the segment standard, so the drawer box is built 1 inch narrower than the cabinet opening.
Cabinet shops and contractors building heavy-load drawers under worktops will find the combination of over-travel and 198 lb capacity directly useful — neither spec is available on a standard cabinet slide. Designers specifying handle-less or overlay kitchens with deep upper shelves or pantry towers benefit from the over-travel clearing the face frame. Homeowners tackling a renovation who want a slide that handles a loaded pot drawer without noise or bounce will get both from this one. The zinc finish suits any cabinet interior where the slide is not a visible design element.
It is a true damped soft-close — an integrated damper catches the drawer in the last portion of travel and controls the close to a quiet stop. It is not a spring self-close, which would pull the drawer shut without damping. The two behave very differently under a heavy load.
The drawer member travels 1 inch beyond the slide's nominal 20 inch length, so the drawer clears the cabinet face by that margin. On a standard full-extension slide the drawer stops right at the face; here it pushes past it, which is the detail that matters under a counter overhang or behind a deep face frame.
No. The slide is non-handed — both pieces in the pair are identical and fit either side of the drawer box. Order the pair count that matches your drawer count.
The slide installs in face-frame cabinets, but the rear end of the slide needs support at the back of the cabinet. Use the appropriate rear mounting brackets for this series, sold separately. Without rear support in a face-frame installation the slide is not properly anchored.
Per pair — one pair of slides (two slides total) carries 198 lb. Load ratings in this category are always stated per pair.
When a standard full-extension slide cannot reach past the face frame and a standard load rating leaves no margin, this 20 inch Fulterer over-travel soft-close slide covers both gaps — damped closing included.
Sold In: 1 Pair
