Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the 28 inch side-mount bracket for the Fulterer 5400 series, a non-handed steel bracket in a zinc finish designed to anchor the rear of a 5400 series slide in face-frame cabinets and other installations where the back of the slide needs independent support.
A 28 inch slide is typically working in a deep cabinet — a tall pantry pull-out, a full-depth base roll-out, or a large utility drawer where the cabinet interior runs to its practical limit. At that depth, the rear of the slide is far from the cabinet face and the load on the back end is real. The 5530 bracket plants the slide firmly at the rear, keeping it level and stable through the full travel cycle. Without that rear anchor, a long, loaded slide can rack or deflect, and a pantry column that weighs anything worth moving will find that weakness quickly. This bracket is the fix built into the system from the start.
The steel body handles the structural demand — holding a loaded pull-out true across thousands of open-close cycles. The zinc finish protects against the surface oxidation that indoor humidity eventually brings to bare steel, keeping the bracket functional and presentable over the long term. Because this bracket is engineered as part of the Fulterer 5400 series program, the dimensions, hole patterns, and geometry are matched to that slide family. Do not pair it with slides from other series or brands; the fit is not guaranteed outside the 5400 system.
Cabinet shops and contractors building out deep pantry cabinets, tall utility pull-outs, or full-depth kitchen roll-outs in face-frame construction will find this bracket essential rather than optional. Designers specifying Fulterer 5400 series hardware for a kitchen or pantry layout should include the matching bracket length in the same order as the slides — they are part of the same installation, and a 28 inch slide in deep face-frame work almost always needs this rear support. Homeowners retrofitting a pantry pull-out into an existing face-frame cabinet should confirm the cabinet's interior depth allows for the full slide-plus-bracket assembly before ordering.
No. The 5530 bracket is engineered for the 5400 series. Hole patterns, dimensions, and mounting geometry are specific to that slide family. Using it with other Fulterer series or other brands is not supported.
Rear bracket requirements depend on your cabinet construction and the slide's installation instructions. In face-frame cabinets, the rear of the slide typically lacks a direct mounting surface, making the bracket necessary. In frameless cabinets the side panel may support the slide directly — consult the 5400 series installation guide for your specific setup.
The bracket is non-handed, so a single set covers both the left and right side of the installation without ordering separate left and right versions.
The bracket is steel with a zinc finish, built as part of the 5400 series system. Load capacity for the complete installation is determined by the 5400 series slide rating — the bracket is matched to that system and is not the limiting factor in a correctly specified install.
A deep pantry or heavy roll-out is only as solid as its rear anchor. Pairing the 5530 bracket with the 28 inch 5400 series slide closes out the installation correctly and keeps the pull-out tracking true for the life of the cabinet.
Sold In: 2 Set
