KV 8405 10-Pair Box 24" Hold-In/Anti-Rebound Side Mount Over-Travel 100 lb Ball Bearing Drawer Slide, Black, 8405B EB 24

24 Inch Over-Travel Ball Bearing Drawer Slide For Dark-Finish and Black Interiors

The Knape and Vogt 8405 Series is a 24 inch side-mount ball bearing drawer slide in an Ebony Black finish, rated 100 lb per pair, with 1 inch of over-travel and a hold-in anti-rebound detent. It is built for drawers that need to clear a countertop overhang or a deep face frame — and for cabinets where a black interior calls for hardware that disappears into it.

Key Features

• 1 inch of over-travel carries the drawer past full extension, clearing counter overhangs and deep face frames so rear contents are fully reachable.
• 100 lb weight capacity per pair handles a loaded kitchen or utility drawer with room to spare.
• Hold-in anti-rebound detent keeps the closed drawer from bouncing back open when shut firmly — no spring, no damper, just a positive catch.
• Steel ball bearings in full-length raceways deliver smooth, consistent travel on every pull, even under load.
• Non-handed design means both slides in the pair are identical, so there is no left-right sorting on the bench.
• Ebony Black finish integrates cleanly into black-painted or dark-melamine cabinet interiors instead of showing as a silver stripe beside the drawer box.

Where Over-Travel Makes the Difference

A standard full-extension slide stops at the cabinet face. This 8405 Series slide travels 1 inch beyond that, pulling the drawer out from under a countertop lip or past a thick face frame so the back of the drawer is reachable without reaching blind. That extra inch matters most on island drawers, drawers under deep overhangs, and any run where the face frame is set well in front of the cabinet box. The hold-in anti-rebound detent complements this — once you push the drawer home, the detent holds it there and stops it from drifting back open after a firm close.

Finish and Construction

The slide is cold-formed steel with an Ebony Black coating over both the cabinet and drawer members. In a black-painted interior or a dark-melamine box, this finish stays visually recessed when the drawer is open rather than drawing attention to the slide hardware. This is a functional indoor finish suited to dry cabinet environments — not a stainless or corrosion-resistant coating for wet or exterior use. The ball bearing system runs in full-length raceways along both members for smooth, consistent travel under the rated 100 lb load.

Who This Slide Fits

Cabinet shops and installers reach for the 8405 when the job calls for over-travel and a black finish in the same slide — a combination the standard 8400 Series does not offer. It is equally at home in residential kitchens with black or dark cabinet interiors, media and bar cabinetry where the hardware should blend in, and commercial millwork where black is a spec color. This SKU ships as a Bulk-Pack, so it is priced and packaged for the shop running multiple drawers, not single-unit retail. Build the drawer box to leave 1/2 inch of side clearance for each slide, and add the appropriate KV rear mounting brackets (sold separately) if the installation is face-frame construction.

Frequently Asked Questions

Over-Travel and Black Finish, Ready for the Shop

When the design calls for black hardware and the drawer needs to clear an overhang, the 8405 Series in Ebony Black handles both without a workaround — one slide, one pair, ready to install.