Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-SC4513 series delivers a 22 inch full-extension, soft-close side-mount ball bearing drawer slide in stainless steel — the material of choice when the cabinet faces moisture, washdown, or corrosive conditions where zinc-finished slides fall short. Sold as a pair.
Zinc-finished slides cover most dry indoor cabinetry without issue, but certain environments push hardware harder. Marine galley cabinets, outdoor kitchen drawers under a covered patio, restaurant prep-line casework, lab or medical cabinetry, and high-humidity bath vanities all create conditions where a zinc finish degrades over time. The ESR-SC4513's stainless steel members hold up where standard finishes do not. The soft-close damper adds a layer of noise control that matters in commercial and hospitality settings — a drawer that closes quietly under a loaded pass-through is a detail clients notice. For any project where the drawer hardware needs to stay presentable and functional despite regular exposure to moisture, steam, or cleaning chemicals, this slide earns its premium.
The slide is built from stainless steel throughout — not zinc-plated steel with a stainless appearance, but stainless material in the members and raceways. Ball bearings run in full-length raceways for smooth, consistent travel under load. The stainless surface is a functional finish that holds its appearance in wet service without the rust spotting or white oxidation that develops on zinc plating in humid conditions. This is an indoor and covered-outdoor material; for direct outdoor exposure or salt-air marine environments, confirm the stainless grade is appropriate for the specific application before specifying.
Cabinet shops fitting out commercial kitchens, hospitality buildouts, lab furniture, or high-end residential projects with outdoor or wet-area cabinetry will find the ESR-SC4513 is the right tool for the job. It suits any designer or contractor who needs the soft-close experience — no slams, no noise — paired with hardware that will not corrode under real-world use conditions. At 75 lb per pair, it handles standard kitchen and bath drawer loads comfortably. Homeowners finishing a custom butler's pantry or a built-in bar cabinet with frequent splash exposure have the same argument for stainless: the extra upfront cost pays back in hardware that does not need replacing after a few seasons.
It is genuine soft-close — an integrated damper slows the drawer to a controlled, silent close. It is not a ramp or spring self-close, which can still slam under a full load.
The 22 inch figure is the closed slide length, not the travel distance. Full extension means the drawer member travels approximately the full slide length, bringing the entire drawer out to the cabinet face — but the slide length and the drawer travel are two separate specs.
Build the drawer box 1 inch narrower than the cabinet opening to leave 1/2 inch of side clearance for each slide — one per side.
No. The ESR-SC4513 is non-handed, so both slides in the pair are identical and fit either side of the drawer.
Side-mount slides in face-frame cabinets need support at the rear of the slide. Rear mounting brackets are typically required for face-frame installations and are sold separately; confirm bracket compatibility with this Sugatsune series before ordering.
One pair — two slides — per order.
When the environment is tough enough to corrode ordinary hardware, specifying stainless from the start is the move that keeps the project looking right and the drawers working years down the line.
