Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National SW Series tambour door is a solid red oak panel built for appliance garages and cabinet openings up to 12 inches wide, supplied unfinished so it can be stained or painted to match any kitchen design.
Appliance garages are common in kitchens where a toaster, coffee maker, or small appliance lives on the counter but needs to disappear behind a door when not in use. A 12-inch-wide opening is on the narrower end of the appliance garage range, which makes this panel the right fit for a single-appliance enclosure built into a corner run or between two upper cabinets. The tambour format rolls the door up and out of the way rather than swinging it into the work zone, which is why it is the preferred door type in tight counter spaces. This panel is the door itself; the track hardware that guides it must be ordered separately.
Red oak is a hardwood with a pronounced open grain and warm reddish undertone that reads naturally in traditional, craftsman, and transitional kitchens. Because this panel is solid wood rather than veneer over a substrate, the slats have consistent depth and can be sanded and finished the same way as solid cabinet doors. At 3/16 inch thick with a flat edge profile, the slats sit flush against each other when closed and flex smoothly through the track curve when the door rolls open. The unfinished state is an advantage for a custom cabinetry project: the installer can apply the same stain or finish used on the surrounding cabinet boxes before the door ever goes into the track.
Cabinet shops building custom appliance garages into a kitchen remodel reach for this panel when the client's design calls for red oak to match existing cabinetry. Designers specifying a tambour enclosure for a narrow counter run will find the 12-inch width covers the opening without requiring a wider panel to be cut down. Homeowners finishing a renovation who need to replace a damaged tambour door in an existing red oak kitchen are also well served here, since the solid wood construction and unfinished surface make it straightforward to match the surrounding finish. The track, mounting hardware, and any guides the installation requires are sold separately and should be confirmed against the cabinet opening before ordering.
No. This SKU is the tambour door panel only. The track, guides, and mounting hardware are sold separately and need to be matched to the cabinet opening and the specific tambour installation.
Tambour panels can typically be trimmed in length to fit a shorter opening, but solid wood slat panels require careful handling to avoid separating the slats from the backing. Test a cut on a scrap end before shortening the working panel.
Red oak accepts oil-based and water-based stains, wiping stains, gel stains, and clear topcoats. Because oak has a pronounced open grain, a grain filler or sanding sealer can help achieve a smoother finish before topcoating if the design calls for it.
All three are 95-inch by 12-inch red oak tambour panels in the SW Series, but they differ in slat thickness and edge profile. This SW-30 panel has a flat edge profile at 3/16-inch thickness. The SW-42 is also flat edge but at a different thickness, and the SW-15 has a half-round edge profile. Choose based on which profile matches your track and the look you are after.
This solid red oak tambour panel gives a narrow appliance garage a finished, wood-grain door that can be stained or painted on site to match the surrounding cabinetry before it ever rolls into place.
Sold In: 1 Each